HOW TO REMOVE ANY DOOR HANDLE ON PEUGEOT 508!

Hello everyone and welcome to a new episode in howtodo. In this episode I will show you how to remove the door handles on a Peugeot 508.
Disclaimer:
Due to factors beyond the control of HOWTODO, I cannot guarantee against improper use or unauthorized modifications of this information. HOWTODO assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. HOWTODO recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of HOWTODO, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not HOWTODO

[@leslienagy7949]

Thank you it worked. 🙂🚀

[@HOWTODO0828]

Your welkome mate 🙏

[@bublydragon7137]

How do you remove it completely? With wires? Xir wraping, thank you!

[@HOWTODO0828]

If you want to remove the wires wich are connected to it you have to remove the interior door panel and the rest of the parts from Inside the door. This când only be done from inside the door after removing the door panel

[@Slava-om1sz]

Can a keyless sensor be replaced inside this handle?

[@HOWTODO0828]

You need to replace the whole handle I think 🙏

[@tamamboylekalsn]

Removing was easy but it was painful to put it back in

[@HOWTODO0828]

Yes, sometimes it's more difficult to assemble everything back together then to remove or dismantle the items

[@tamamboylekalsn]

@@HOWTODO0828 but your vid helped I lot. Thank you. We did on Peugeot 308 t9. Only difference was t30 bits needed to do.

[@robertbeavis3812]

It took me several hours to get the key lock back in. What you see in CZcams videos is a lot of shaking and jiggling, this is not normally how mechanical things should work. The key lock inserts into a carrier which the T30 Torx screw undoes to unclamp the lock. When reassembling, the carrier doesn't appear to move back far enough despite it going back to a solid position with a final 'click'. There's actually further for it to go, but the mechanism will only move far enough ***if the handle / door release is FULLY pulled***. This gives you the additional two millimeters of movement of the carrier necessary to insert the key lock easily and smoothly - no agressive shaking, pushing, pulling and jiggling is necessary.