What can be done if air suspension is all grey out in adaptive air setting in the mmi section. I removed wheel to check leaking air took line off valve block and now the level settings don't light up when I turn on ignition. You advise us welcome. I do have a vcds
To be honest, I didn't quite understand your question. So if the level options aren't available, then check if your car has cart lift mode active. That is, as soon as you lift the vehicle, the mode is activated and then all levels are gray. That means you have to switch off the car lifting mode. Assuming there isn't a problem with the lines or the valve block or the compressor. To deactivate the mode, go to the operating panel at the CAR, then go to SETUP and then turn off the lifting mode.
bro i need your help i have an audi a8 2010 and i have problem with air suspension... I was doing service and mechanic forget to lock it up and after some time my car start geting lower in front end when i leave it over night.. Sometimes its fine it stays. Also sometimes it gets lower after only 30 min and as soon as i start my car it get at normal height. I put my car on diagnostic and it only shows one error c11aff0 but when i drive it i have no problem car drives fine and no strange noises, also when i turn off car air compressor stop aswell.. Can u please help beause in my town we dont have good mechanic and i really need help :)
❤❤❤❤
👍👍👍👌👌👌
What can be done if air suspension is all grey out in adaptive air setting in the mmi section. I removed wheel to check leaking air took line off valve block and now the level settings don't light up when I turn on ignition.
You advise us welcome. I do have a vcds
To be honest, I didn't quite understand your question. So if the level options aren't available, then check if your car has cart lift mode active. That is, as soon as you lift the vehicle, the mode is activated and then all levels are gray. That means you have to switch off the car lifting mode. Assuming there isn't a problem with the lines or the valve block or the compressor. To deactivate the mode, go to the operating panel at the CAR, then go to SETUP and then turn off the lifting mode.
Did you figure this out? I have the same issue right now. Tow mode is on and grayed out to where I can't turn it off.
Had same problem. You have to do the same as in video. Relearn a Air suspension system...
why introducing different vallue for each wheel? im stuck to this question , after putting to left 380 and right 384 , it will not be "leveled"...?
You may need to recalibrate it or check the suspension relay behind the panel above where you're shins are when sitting in the seat
After this is done can you show all levels highlight and you can alternative between levels
Once you have the values coded and saved. You can use the air suspension normally and all levels are available.
bro i need your help i have an audi a8 2010 and i have problem with air suspension... I was doing service and mechanic forget to lock it up and after some time my car start geting lower in front end when i leave it over night.. Sometimes its fine it stays. Also sometimes it gets lower after only 30 min and as soon as i start my car it get at normal height. I put my car on diagnostic and it only shows one error c11aff0 but when i drive it i have no problem car drives fine and no strange noises, also when i turn off car air compressor stop aswell.. Can u please help beause in my town we dont have good mechanic and i really need help :)
Dali si Probao sa VCDS da Codiras Sve 4 osovine na novo?
@@jugoslavspromenio sam oba prednja jastuka sa amortizerima, kompresor i ventil blok i sad radi kao nov 😂
Meiner pumpt sich vorne nicht schnell genug auf und geht dann in Fehler
Der Kompressor ist zu 100% defekt. Du must dir mIt VCDS die wehrte ansehen wi hoch ist die Temperatur vom Kompressor wen er lauft...
@@jugoslavs also real 27° und berechnet um die 90°. 8 bar schafft er. Hinten ging er ja in 3-5 Sekunden hoch aber vorne nicht…