Rx7 12a Turbo : how to make the most power!
Vložit
- čas přidán 15. 01. 2024
- We put a nice size turbo and intercooler on mikes 12a but in the proccess of pulling the front cover to weld in a oil drain we find bad news and found a spun bearing that turned in to a rebuild but just a fresh bearing press and new e shaft
Turbo rotary
Rotary sound
How to build a rotary
How to turbo
Race car
#rotary #rx7 #13b #mazda #12a #turbotax
Support the people that support us Buy some led lights
Auxito Referral Link www.auxito.com/kuE3A8VuIk_tsZ
Discount code 15% off RogueSpeed
Follow on Instagram / roguespeedperformance
Say hi visit us on FB / therogueonesny - Auta a dopravní prostředky
this is so helpful to my build thanks!
No problem and thank you as well for watching !!
Now, this is content!
Deff could have been better with the filming but made dew with what i did
We need to do an update video on it sooooo much has happened since this video
Need to work on it and film not watch vids on your phone lol
How are you running the coolant lines for the turbski? I don't quite understand the best path for the flow of coolant. Are you running from the heater core bypass and back into the thermostat housing?
There are no coolant lines for the turbo its not a ball bearing turbo
@TheRogueOnes I have a journal bearing turbo with coolant ports
Look good I just installed a ACT pressure plate on my 7 what a different and yes I recommend to use different fan and what u did for fuel pump in tank or in line?
Your recommend a different fan not going to find much better than a 16 inch spal. Thats 3000cfm. Other than a brushless it has a 300lph lift pump to a 400 aem in a surge tank
We getting a rotary swap beemer update soon?
😉 when i edit the vid made both at the same time part of the issue not filming much with this one lol
Gotcha, looking forward to watching that one!
What exhaust manifold custom ?
He got some manifold from Australia fits terrible buts the down pipe in the manifold had to run a spacer between the turbo and manifold and do a bunch of bullshit cuts and welds to clear the manifold with the down pipe