Fix Broken Rear Wiper Toyota Prius

Sdílet
Vložit
  • čas přidán 23. 08. 2024
  • Loctite Threadlocker
    tinyurl.com/qbb...
    During the winter my rear windshield wiper got damaged due operating the rear wiper before snow and ice removed. The aluminum groove in the wiper arm is now damaged which causing wiper stop functioning. I am going to show you how to fix this problem.

Komentáře • 17

  • @ryuandbrothers2073
    @ryuandbrothers2073 Před 4 lety +1

    very helpful now let me give it a try. Fixed it took 1-2mins only thanks heap!!! I'm 8 years old.

  • @MLHollums
    @MLHollums Před 7 lety

    Thank you so much for this! I let a local kid shovel my walk and clear off my car, and didn't notice right away that he'd pushed my wiper so hard that 6 inches of the tip of the blade was protruding off the side of the car. Following your instructions, took me less than a minute to fix it (lucky for me, there was no debris in there!)

  • @severdislike4222
    @severdislike4222 Před 8 lety

    The information here was much appreciated! Got the wiper working properly again after a 4' snow heap messed up the alignment on the wiper.

  • @jimmy_jamesjams_a_lot4171

    GREAT FIX! To think that stuff is made in such a way that basically ensures your business in the near future by their proprietary rights. Toyota would likely have charged the owner a good 200$ for that work alone! THANKS A LOT FOR SHARING!

  • @edwardbruce5390
    @edwardbruce5390 Před 8 lety

    Tim, This is just what I needed. Thanks.

  • @LifeInZadar
    @LifeInZadar Před 3 lety

    Thanks! Will give this a try today.

  • @wesm9178
    @wesm9178 Před 9 lety

    Thanks Tim, this is very helpful.

  • @felixyang4094
    @felixyang4094 Před 8 lety

    I will try first, thank you!

  • @salukiconvert
    @salukiconvert Před 6 lety

    thanks Tim Z!

  • @sawyer7as
    @sawyer7as Před 7 lety

    Great work dude!

  • @mslippity
    @mslippity Před 9 lety

    very helpful. Thank you.

  • @4heart
    @4heart Před 7 lety

    Thanks man!

  • @drizler
    @drizler Před 6 lety

    If it’s stripped out it looks to me to be a perfect place for JB WELD Clean and roughen ( the rougher the better) the inside then press in a ring of JB. Not a big wad but enough to fill the stripped splines. The shaft splines after tightening down will press form it just like new. If it strips again the JB will chip, scrape out with little more effort than the original plastic and you can just fix it again. The prices they charge for this stuff are absolutely extortion!

  • @physicalivan
    @physicalivan Před 6 lety

    Thank you man. 👍

  • @amanmunawar4045
    @amanmunawar4045 Před 8 lety

    Cheers tim:-)

  • @MalawisLilleKanal
    @MalawisLilleKanal Před 6 lety +1

    Small amount....