I Rebuilt My Polaris RZR 800 And Blew It Up Again In Under 5 Minutes
Vložit
- čas přidán 29. 08. 2024
- This video is all over the place. I had a bad time with not being able to find alot of the clips I made throughout the rebuild process. Anyway, It did end up running after the rebuild but that was short lived. It blew a headgasket in literally under 5 minutes of run time.
SUBSCRIBE!
/ @ramenbuilt6411
MY EBAY STORE
www.ebay.com/s...
Right on dude, keep it up, I’ll be watching 👍
Hopefully will start getting some stuff done in a week or two when the gasket get here🤞🏼 thanks for watching!
Install the pressure guard oil presure control valve to solve any oil pressure problems
if it blew the head gasket right away check your case and head for warpage.
The head bolts are torque to yield, so they stretch when torqued, you have to use new ones every time you pull the head off.
Ramen, what lift setup you have on yours. I"ve been looking at something not to high and yours look perfect.
It’s the stock “s” suspension with the shocks tightened up a lot. I wouldn’t recommend as it rides horrible. I’d recommend going with a 2 inch or so bracket lift.
So the 900 plastics fit? Cool car dude
I didn’t put them on so I’m not sure what goes into putting them on but yes they definitely can fit!
What brand of parts u order and were u order them from?
what wheels are those?? I might be getting a 800!!
looks like oil pressure relieve valve got stuck causing to much oil pressure
What lift is that sits real nice
It’s just the stock 800s suspension with the coils tightened up a lot. It rides terrible as it is.