Rear Light Wiring Kit Install

► GET THE GEAR HERE bit.ly/4WDSupa...
Thanks for watching from all the team here at Adventure Kings and 4WD Supacentre. Remember to hit that SUBSCRIBE button so you don't miss a moment of this cracking expert advice that every camper, overlander, explorer and 4WDer must hear!
► ABOUT US
Adventure Kings is an Australian owned company offering quality 4WD, camping and outdoor products to help you enjoy quality time outdoors. We carry a wide range of products designed to make your 4WD or camping trip that much more enjoyable. Products range from air compressors, awnings, awning tents, camping gear, exhausts, led lights and more!
We have all the right gear you need to keep you out on the tracks for longer at incredibly low prices every day. You can get all your gear at your nearest 4WD Supacentre store or online.
► OTHER VIDEOS YOU MAY LIKE:
• Beginners Guide To Camping: bit.ly/3iz5gKM
• Beach 4WDing Secrets Revealed: bit.ly/2R9chH0
• Torture Test - Lethal LED Lights: bit.ly/3fEzmLi
• Off Grid 12V Battery Masterclass: bit.ly/3c8uICO
• Solar Regulators Explained: bit.ly/3fBvXNd
► Check Out Our Products - bit.ly/3lwnr5D
► Check Out Our Social Media:
• Facebook - bit.ly/3fpRGav
• Instagram - bit.ly/3ClyDrI
*NOTE: This description contains links that allow you to find the items mentioned in this video. Thank you for your support!

[@jimtsaoucis4207]

what did you use to connect wire/conduit with ties to roofline- looks like self-adhesive tie down of sorts?

[@wavebarell2603]

Can I set it up to my Deep cycle battery in the back, rather than connect it to the engine battery
which would run it flat every time I would use the lights. ??

[@AdventureKings]

Hi there,
While you would be able to do so, we would advise that ADR requirements do necessitate that the lights be attached to the light type they're supplementing, otherwise the only concern would be the drain on the battery.
Regards, Andrew

[@MrSpitfireMustang]

Did I miss something? Aren't rear worklights meant to be wired to your reverse switch if they're white?

[@AdventureKings]

Hi there,
If used as a reverse light the lights do need to be tied to the reverse lights in the unit, and need to be set in a way that will not dazzle or otherwise impede the vision of other drivers. The rulings on worklights however can change from state to state so it's hard to give a generalised note on them as a result.
Regards, Andrew

[@user-dz4dh8vm7k]

That is the most messiest wiring I have ever seen. 😂. Good video though.

[@djfdel]

Can I chop the ends off that go to the battery and wire it to a cig plug? I’m running a power station as my 2nd battery.

[@tomwinning]

So does this kit do 2 light or do I need to run this cable type twice (for each light)

[@aaronsharp843]

does 2 lights mate

[@ashlemon5704]

Will this do anything to the starter battery when the lights are on but the car is off?

[@AdventureKings]

Hi there, the harness works as an extension of the high beams on the vehicle. Kind regards, Rachael

[@ashlemon5704]

@AdventureKings ok thanks, so couldn't use them as extra lighting for camping? Only when the car is on?

[@user-dz4dh8vm7k]

@@ashlemon5704 100% you can. As long as the plug isn’t high beam triggered. Yes you will drain your starter battery if the alternator isn’t charging it.

[@lucamartin2301]

What wiring kit is that

[@exogator]

Watch the first 1 min or the video dude

[@twain1669]

Kickass tow pack extension kit