Video

Hi there, As the unit connects to both the positive and negative of the battery it forms a full circuit and will generally ground via the vehicles electrical system. Regards, Courtney

Hi there, So long as it is able to register an active ignition it will intake power from the starter battery, and will be fine with either a smart or non variable alternator. Regards, Andrew

Hi there, So long as it is able to register an active ignition it will intake power from the starter battery. Regards, Andrew

Hi there, Thank you for the comment, I do know we've got a team working on installation videos for our more advanced set ups, and I'll forward this so they have it on their radar! Regards, Andrew

@@AdventureKings That would be great, but it would also be great if complete instructions were actually supplied with the awning bracket or the awning as your left to wing it, as there is no true instructions on either product as to how many bolts per bracket, I assume 2 for the front and 4 on the back. Have a read of both instructions and you’ll see what I mean there is clearly a missing piece of the puzzle.

Hi there, Unfortunately the sliding top is built into the left hand side of the unit and cant be swapped, I'm sorry. Regards, Andrew

@@AdventureKings hey mate Ive nearly completed the change I’ve from left to right side. Just need a few new holes drilled and some slight trimming done on rear panel 👌

Hi there, This remote is suited for our 40amp unit specifically to get the most out of that capacity. Regards, Andrew

Hi there, While it unfortunately doesn't have a cigarette input port, there are alternator inputs on the unit you could use to charge via the vehicle alternator that would fit the same bill via a different approach. Regards, Andrew

@@AdventureKings thanks for that, and the Victron option to charge?

Hi there, Thank you for the comment, we would recommend getting in touch with our Customer Service team, as they would be able to pull up some wiring information should you need to swap out to negatively switched set ups. Regards, Andrew

​@@AdventureKings *I've already cut off the connector, there were one red and one black wires. It was easier to use my one connectors. It would be much more comfortable if this information would be on the box.* P.S. the light bar works excellent

Hi there, While that would work, we recommend the starter battery should you be looking to add charge to your 12v system via a DCDC / Alternator. Regards, Andrew

Hi there, Just need to piggyback the ignition off of the positive, as that's where the power check runs off of to confirm that the ignition's active. Regards, Andrew

Hi there, Thank you for the feedback, that's some handy stuff and we'll pass it on to our design team! Cheers, Andrew

Hi there, These battery types are not compatible in the same system as there is nothing stopping the lithium completely discharging your other battery. This would require an isolator that doesn't allow backflow, but we would recommend consulting your local auto electrician to ensure your setup is safe and viable. Regards, Courtney

Hi there, Thank you for the comment, while it is unfortunately only able to take 12v inputs via the labelled input sections, in regards to fire resistance, the unit is compartmentalised to reduce any damages caused by a short or items being wired in incorrectly. Regards, Andrew

Hi there, I can confirm that they are compatible with batteries of that size, please do note that it is designed to have an Anderson to Ring Terminal cable set going to the starter battery rather than the Cig plugs in the vehicle so that you get a full power input from the alternator. Regards, Andrew

Hi there, Unfortunately we do not sell fuse boxes and this is not included with the inverter. Regards, Courtney

Hi there, As demand has declined we've placed our camper trailers on wind down, as such items generally go through large peaks and troughs so while they're on that low we're currently not taking orders for the units. Regards, Andrew

Hi there, We wouldn't recommend wiring the batblock and battery box together unless you are running the same size and batch battery. Regards, Courtney

Hi there, That is correct! Regards, Courtney

Hi there, Unfortunately we do not ship internationally at the moment! Regards, Courtney

Hi there, You can run the alternator lead to a cig plug socket in the rear of the vehicle. It would depend if you have constant power from the plug if you would need to unplug it. If it is only to the ignition it wouldn't need to be unplugged. Regards, Courtney

@@AdventureKings would that be enough power though or would it lose too much voltage through the cig plug? Thanks

Hi there, That is correct! Regards, Courtney

Hi there, This anderson plug can be used for additional input or output. Regards, Courtney

Hi there, I can advise that the isolator switch is a full isolation switch, so when active will cut the battery off completely. Regards, Andrew

Hi there, Thank you for the comment, it is, or is close enough as we've added some improvements and refined some of the components specifically for this design so it runs even better than the old DIY unit we put together. Cheers, Andrew

Hi there, I can advise that the units do come with mounts, please do note they can fall into the sides of the box and get wrapped up in packaging, if you aren't able to find them, please get in touch with our warranties team here: service.4wdsupacentre.com.au/returns or run by our guys in store as we will be able to work with you to resolve the issue. Cheers, Andrew

Hi there, Thank you for the comment, I can advise that while we don't yet have them in our range, there are battery trays that would fit the slimline, or otherwise I've seen some nifty set ups with brackets that slot in around them too. Regards, Andrew

Hi there, Unfortunately we only have the prebuild units in our range, though I've sent your interest through to our product team so they know there's interest. Cheers, Andrew

Hi Benny, Our deals do change day to day but they're currently up on our site at $349.00 for 12/06/2024 for the lithium 100AH. Cheers, Andrew

@@AdventureKings thankyou

Hi there, Thank you for the question, by cutting down the system, and having it directly integrated there is less area of resistance and far less heat generated, on top of this the unit is ventilated to keep everything normalised. Regards, Andrew

Hi there, This is not necessary, however we would recommend a 25A wiring kit if you were wanting to connect this to your alternator. Regards, Courtney

@@AdventureKings Deleted all the comments 💀😢

Hi there, We recommend a 15A cig plug. Regards, Courtney

120amp*

@@frysee8890 I saw that 3000 watt bundle also. I don't think one should try running that big an inverter with a 120ah lithium. Nor should they really be selling it as a bundle (to avoid confusion) if this does 1500 watts max. But double check with Kings of course :) What are you trying to run that you need 3000 watts for?

There 120ah batteries will only pull 120amps. You can use the 3000w inverter however only appliances that use under 1500watts. Seems pointless. Better off just buying there 1500w inverter. Even the 120ah battery is maxed out running that

Toaster, kettle, hair dryer... All have 2k watts on them or thereabouts. I assume I'd have to buy appliances with 1500 watts or less then for the 1500 inverter?

@@frysee8890 nah you can use your regular appliances and a 3000w inverter. Just need a battery or bank of batteries big enough to draw the correct amount of amperage. Also the wiring supplied with the new battery box wouldn’t be anywhere near the size (thickness) required for the 3000w inverter. Basically they are happy to bundle shit together to think your getting a bargain when in fact it can’t even be used together in conjunction

If you watch the full video, it mentions that currently the biggest is 120ah - but in the future with technology advances and batteries getting smaller but having more amp hours, it could mean that you could have a larger ah battery in there ;)

Hi there, As this is connected to the cig plug this ignition wire is not needed to connect to the outboard on the boat. Regards, Courtney