Husqvarna 125b: Carburetor Install

This video shows the process I used to install a new carburetor on my Husqvarna 125b leaf blower. The installation was pretty easy and made a huge improvement in the blower's performance!
Carburetor Kit:
www.amazon.com...
Ethanol-Free, 2 Cycle Fuel:
TruFuel 110-oz 50:1 Ethanol Free Pre-Blended 2-Cycle Fuel in the Power Equipment Fuel department at Lowes.com
www.lowes.com/...

[@rdiehl7809]

I watched parts of 2 others before finding you. You were the best. Enjoyed your presentation. Thank You.

[@theshopprojects]

Thanks for your comments and for checking out my channel. I'm glad I could help!

[@keithduclos7983]

Well done mate! I followed the video step by step sitting in my chair in front of the computer. I've done this before but it took me twice as long and much harder the first time.

[@TheLawnmowerLady]

Nice video. Clear, concise, great editing. I see you have some great help in your shop. You deserve more subs. Cheers!

[@theshopprojects]

Thank you! I appreciate your comments, and thanks for checking out my video!

[@pablocraft3187]

Definitely helpful.

[@damianbrumfield8057]

I followed this video and even changed my spark plug. It took a couple minutes to fire then it ran great, for probably 5 minutes then it bogged down and would not start again. It felt a little hot but not to bad. Any help?

[@jessesmith3026]

Great work Rob!

[@theshopprojects]

Thanks man! Thanks for checking it out!

[@chrisgarcia2152]

Everytime I start mine an get the high an low perfect it'll die after prolly 2min of use. Can't figure it out?

[@pumpkinpeanut1]

Hi Hasqvarna friend. Once the new carburetor has been installed, does it come with the adjustments so that no adjustments are needed by the person who bought it? I noticed that you just started the rebuilt carburetor on your blower without adjusting the High and low adjustments. I also noticed that you did not have to do anything to the idle screw.

[@willkeyworth1878]

Thanks for the super great tutorial. I checked the spark, good. I checked the exhaust, good. I replaced the carb and gas, good. Still will not start. It's a relatively new machine 😞Any OTHER ideas?

[@joeyvanostrand3655]

Headgasket?

[@christenlawless5284]

Thanks so much for this video!

[@pedroparravicini7366]

Thanks for your help 👍

[@theshopprojects]

Thanks for checking out my channel!

[@aaronsesula2033]

Worked that’s weird but it better than a repair bill

[@qfdforme]

Nice video, thanks.

[@theshopprojects]

Thanks for checking out my channel!

[@sanityone649]

That rubber plug in my fuel tank was way harder to remove than the one in your demonstration. I used a screwdriver just like you did…and was wondering if I was going to be successful. I have a question…after installing a new carb…my 125B started right up…just like it was factory new. However…it seems to run fine by the sound of it, but it vibrates more than it did before when blowing leaves. Any ideas?

[@theshopprojects]

SanityOne, thanks for checking out my video. I would just make sure that everything is tight, from when you put the unit back together. If it still vibrates really bad, I'd have a repair shop look it over.

[@Dusrz3]

Hey its Tristan

[@theshopprojects]

Hey man! Thanks for checking out my video!