Video

Any one elses f70 water pump rebuild kit come with 2 black seals? Mine did

Awesome video. Appreciate you getting to the point and not blabbing on about other random unrelated stuff. First time doing an impeller an Got it all taken care of in a little over an hour. Could have went way faster but wanted to make sure it was done right with no extra parts left over. 🤣 Thank you!

Im curious to see the condition of my thermostat, if i open it up can i reuse the same gasket?

Great video manual! It will be great if you show fuel filter change too. As I know there are two kind of fuel filter inside the engine.

Good ole Ford engineering

Thank u from France

Thank you

Salut, super ta vidéo👍 Pourrais-tu faire une vidéo sur le changement des anodes internes ainsi que du filtre à essence ? Merci

Well done! Every CZcams DIY should be this good! Thanks!

Perfect no nonsense video, thanks

Great video it found it to be very informative. 😊

Very nice video. I NEED one of those ratchets! 😉

You never took off the propeller! What if there is fishing line tangled in there? What about greasing the propeller shaft?

Using the Mercury special lubricant 101 is standard Yamaha maintenance?

I guess the music is there for all the short attention span viewers?

Now that the door panel is removed Not sure how to disconnect the 3 cables ? You make it look to easy Is there a trick ?

This vedeo was very helpful for me. To do pm on my Yamaha 70mm motor

What was the problem?

Awesome Video... I paid $310.00 for my 1st 100-hour service on my Merc 4S 150. I'm 15 hours from my next and I believe I'm going to follow your tips, along with the manufacturer's recommendations. You didn't show it here, but are there torque tensions for the bolts and prop lug?

Great informative video. Will definitely share! Thank you

Good video, very helpful. I have never seen a torque spec that was without lube. You're not doing it wrong by adding lube, you're doing it right. And not to be picky, you are working with the key. The keyway is the groove in the shaft and impeller.

When draining gear oil tilt up engine so drain is the lowest point.

Will be doing this soon thx!

Thank you boss for the video. I have the same motor on my boat and again, thank you for the super helpful video. Impeller is something I have never changed. My fishing buddies are going to help and I owe them fishing trips to the Coronado Islands in Mexico for yellowtail. We will watch your video before the work.

I know it’s been a while but what’s the deal with these boats? The hull design looks like it’s a tank and would cut through the waves better than any boat but you don’t really hear about them. Would you say it’s the best riding boat? Or does the hull look just trick you?

Definitely neat 😊

can do a timing belt replacement video?

how often to replace the water pump?

Finally got around to fixing this super annoying issue. Awesome video, super helpful!! Although removing and replacing the door keep was definitely the hardest part!! Thanks again!

Thanks mate, going to do mine this weekend

Quiet out there. Always enjoyable to be out fishing. Y’all out @ LoX ?

I just installed this on a Kubota RTV for installation of a GMRS radio and rear work lights. Only thing I would add, make sure you have a 30 to 40 amp fuse on the hot wire from the battery, which should be 12 ga wire to the fuse panel as well, I got the resettable version which also has is a disconnect if needed. Also, add shrink wrap to all your connections.

Do you have a link to where I can find these lights?

Pretty much every car in Ohio 😂🤣😂

How can someone not feel that while driving? 🤯

😮 Huh? I wonder what could be wrong. I think you might have got your full use out of your brakes. Maybe next time don't be so cheap. And get your brakes done sooner, just my Thoughts

One of my sister's friends brought a car to me with brakes like this. She said that she kept telling her BF that there was something wrong with her brakes, but he just kept ignoring her, so she brought the car to me. He got so pissed off when he found out what she did that he and another guy came to my house and were ready to fight me. Once those guys saw the rotors, they left, it was ridiculous. Chevy guys are the absolute worst human beings on Earth.

That’s a big tone ring.

Them those slotted disks 😂

😂😂 has to be a female

Well I'll be honest I'm very impressed 😅 where is the othe side

You only need the brakes checked every 200k miles.

So what's the answer for us in the gen pop???? I'm in healthcare so your going to have to tell me what I'm looking at. Brakes and rotors from my basic knowledge. Thank you!

Lube em up and send her on her way

The humming noise is to sooth you as you calmly slam into the wall/car_______.

Took me a minute to realize that's the inside of the rotor. At first I thought somebody was pranking them by milling a good rotor. Nope, just wore through the original one.

When I was a brake tech at Midas I saw this. My boss called them stereo rotors the customer turns up the radio to make the problem go away😂

Should it be shifted in rev/foward or ledt in neutral?

great video

What size are the single use gaskets? For engine and foot oil. Thank you!