![Infamous_Duramax](/img/default-banner.jpg)
- 25
- 446 362
Infamous_Duramax
Registrace 17. 03. 2011
I'm just here to have some fun, and hopefully help some people out!
Anyways if you like whatever vehicle related things I do make sure to sub!
Anyways if you like whatever vehicle related things I do make sure to sub!
Clapped put Duramax Cold Start
Old girl has no problems starting, unless its 20 below...
zhlédnutí: 71
Video
Neon SRT 4 UHP and blow off valve install
zhlédnutí 7KPřed 3 lety
AGP Upper hard pipe and blow off valve install on my wifes Neon SRT-4 to get it ready for this summer! Thanks for watching, hopefully this helps someone!
clapped out TDI cold start0.
zhlédnutí 108Před 3 lety
So i might have not noticed that the battery charger cable broke..... not fun fixing that in the cold weather! Thanks for watching I suppose
RIDING LAKE MILLE LACS TRAILS final part
zhlédnutí 60Před 3 lety
final part of ripping up Lake Mille Lacs trails! This is cut short due to my Go-Pro freezing! sorry... Hope you enjoy, new video coming out next week! Music: Benound.com
RIDING LAKE MILLE LACS TRAILS PART 1
zhlédnutí 76Před 3 lety
TODAY WERE RIDING TRAILS AT LAKE MILLE LACS, MN. Sled i'm on is a 2002 ski doo summit 800. This is just part one so stay tuned for part two!!
EASY removal of stickers from your vehicle!! (also works on adhesive)
zhlédnutí 60Před 3 lety
This is by far the easiest way I have ever found to remove any sticker, or trim adhesive or anything of the sorts off your vehicle! If you do it right it won't damage paint or glass!(IF you do it right lol) Hope this video helped some of you, and if you have any other ways that have worked for you leave them in the comments! Link to the eraser wheels: www.amazon.com/s?k=eraser wheel&ref=nb_sb_n...
SUPER SATISFYING CLEANING! Larson Senza revival Part 1
zhlédnutí 630Před 3 lety
I recently picked up this old Larson Senza 210 LX that needs a whole lot of cleaning and TLC! Follow me on the journey on getting this boat back in the water! PART ONE OF MANY!! Follow on instagram: Clifford_6.6 Music: www.bensound.com
DIY REVERSE CAMERA INSTALL. Its so much easier than you'll think!
zhlédnutí 22KPřed 4 lety
This is a super easy way to install a reverse camera on older vehicles that do not have one. You might run into an issue where you can not pull power from the reverse lights so you will have to wire the backup camera and monitor on a switch.\ Follow my Instagram: Clifford_6.6
DURAMAX GETS NEW TIRES AND WHEELS! This took way to long! shenanigans!
zhlédnutí 139Před 4 lety
Duramax gets 20x12x35s off the old cummins!! This is a percect setop for wheel spacers (maybe) and bigger tires! Honestly not a lot of this video is of the tires but ahwell hope you like!! Instagram; Clifford_6.6 music: Bensound.com
DURAMAX GETS A MASSIVE LIFT!!! Day Two!
zhlédnutí 60Před 4 lety
Second and last day of doing the front end swap on the Duramax! Unfortunately i lost a lot of footage, but still wanted to upload what i had!!! Follow the Instagram_ Clifford_6.6 Stay tuned for more videos and content that will only get better! Please like and subscribe! it helps out a lot. Leave a comment if u want to see anything to happen with this truck! Music from Bensound.com
DURAMAX GETS A MASSIVE LIFT KIT! Day 1
zhlédnutí 58Před 4 lety
So to cut a long story short because I forgot to make an intro #amateur I got a Full Throttle Suspension lift from a buddy for a really great price! I knew it would fix front end problems/noises iv been having. And it included a new front diff(Mine is torqued lol) Hope you enjoyed my video! Hopefully it was better than previous videos iv made, and stay tuned for more!! Follor the instagram!! Cl...
NASTY DIFF FLUID! how to and why you should! GENERAL MAINTENCE
zhlédnutí 88Před 5 lety
FOLLOW THE TRUCK ON INSTAGRAM!! Clifford_6.6 Canging the diff fluid on my 2002 gmc sierra 2500 HD. Why you should do it and how to do it basically the same for every vehicle Normally ill change the diff fluid every 4 years or 50k miles Thanks for watching! Please like and subscribe! Music Bensound.com
DURAMAX ALUMINUM DRIVESHAFT UPGRADE!!! CCSB LB7
zhlédnutí 12KPřed 5 lety
Upgraded Alluminum driveshaft for the CCSB Duramax!! this truck came with a 2 piece junk driveshaft that ate carrier bearings. Instagram Clifford_6.6 Driveshaft website: www.driveshaftpro.com/ Music: www.bensound.com/
5 INCH EXHAUST INSTALL DURAMAX!!
zhlédnutí 1,9KPřed 5 lety
The duramax gets a new 5 inch MBRP downpipe back exhaust system! duramax cat stack delete! Music: www.bensound.com
DURAMAX REVERSE LEVEL!!! Part one!
zhlédnutí 412Před 5 lety
Reverse leveling the Duramax so my CV axles are straight and i can do the coolest boosted launches in 4WD! Follow the instagram! clifford_6.6
800 HP CUMMINS daily driver!! MASSIVE BURNOUT!
zhlédnutí 10KPřed 5 lety
800 HP CUMMINS daily driver!! MASSIVE BURNOUT!
DIY WINDOW TINT! Tint like the pro for less!
zhlédnutí 93Před 5 lety
DIY WINDOW TINT! Tint like the pro for less!
NEW DOORS! Getting them ready for paint. Curing the cancer on the duramax part 1.
zhlédnutí 30Před 5 lety
NEW DOORS! Getting them ready for paint. Curing the cancer on the duramax part 1.
LB7 TURBO HORN INSTALL! Is it worth it?`
zhlédnutí 32KPřed 5 lety
LB7 TURBO HORN INSTALL! Is it worth it?`
DURAMAX GETS MUDDY! Fun times in the mud!
zhlédnutí 52Před 5 lety
DURAMAX GETS MUDDY! Fun times in the mud!
HARDWIRED LED STRIP INSTALL.. Clean LED strip install in almost any vehicle!
zhlédnutí 359KPřed 5 lety
HARDWIRED LED STRIP INSTALL.. Clean LED strip install in almost any vehicle!
NOW I CAN PULL ANYTHING! CLASS V HITCH INSTALL ON THE DURAMAX
zhlédnutí 166Před 5 lety
NOW I CAN PULL ANYTHING! CLASS V HITCH INSTALL ON THE DURAMAX
THE DURAMAX GETS PARTS THAT DONT WORK?!?!?! LB7 Used tap shifter install
zhlédnutí 437Před 5 lety
THE DURAMAX GETS PARTS THAT DONT WORK?!?!?! LB7 Used tap shifter install
I may be missing if you posted, but do you have a link for the led kit?
This video is what I've been looking for. Was trying to look for a way to install my LEDs without having to use the cigarette port
I don’t know what to do on the ground wire part
Damn this helped me so much, thank you man, appreciate it
Question, I followed this tutorial and it worked for me, but now I want to add another accessory but I’m wondering if I can just plug it into the same Add A Circuit and just add another fuse on the bottom slot. I connected the add a circuit earlier into an empty fuse slot so I didn’t have to take out an existing fuse. Please help thanks.
Velcro holds them. Problem solved
What’s the fuse kit he used
Connected everything as shown but the strip starts rapidly flcikering. What could be the issue?
Which stripe and brand did you use
I did this and I’m not getting power? Any idea?
Thanks for the videos.One question about replacing rear differential,is there a replacement gasket or what’s up?
Looking to underglow any help? Can’t figure out how to get the cords from outside under the car to inside to plug in usb or old school cig lighter spot
can you link everything u used? like the led u bought and fuses if it doesn’t come with it because i’m thinking about buying this for my step dad for Christmas
Can you hardwire if it's a USB connector?
solder the wires you lazy c#
8:30 i love your boots
Does it matter where u ground? Does it have to be close or far?
Pro tip: the fuse tap doesn’t work the same both directions. If you plug it backwards then the original fuse that was in place will have to bear its circuit in addition to the new circuit you added. The wire should be on the load side. Use a voltmeter and make sure the wire is on the side that has 0 volts.
You could argue that installing them backwards is safer cause now your wire will not be overloaded with what it was originally fused for. The small load that those leds draw probably willnt make a difference either way. If your drawing more than a few amps you should probably run a relay.
@@danielbonner8309 no the original circuit does not use the wire. Check the fuse tap’s diagram for an easier understanding
@@danielbonner8309 also if it’s backwards and the original circuit fuse blows for whatever reason, the new circuit will have no power
@@ahmadchoujaa9452 If the original equipment draws 5 amps and you add a fuse tap to lights that draw 5 amps that's 10 amps on the circuit no matter how you orient the fuse tap.
Can you get away with 10 fuse ?
What if its the usb 1 not the cigarette lighter plug? Can u do same thing?
Double sided tough tape makes it where it will stick anywhere for future reference. Great video!
This was awesome to watch! I’m still figuring out which fuse to put my LEDS onto. Everytime I turn my car on they flash.
Thank you so much, looks Oem (ish)
Very cool video thx, where do you find that fuse adapter? How is called? Thanks!
' what brand name LED lights company... send me a link and amazon... thank
I got those today. Will follow that guide looks quite good.
Tried a couple different fuses until I finally found one that would only get power when the car is start or on, another thing I did was went to Lowe’s and bought some cheap wire and a couple crimp connectors and made the wire from the led Box to the add a fuse a bit longer due to it being on the passenger side. All in all thanks for the great idea
😡😡😡😡😡😡😡😡😡NO HELP AT ALL!!!!!!!!
Can I connect this lightening to Usb instead of fuse ?
my car hasn't fuse box on front side thats why I cant make it.. I have car music "modulator" and it have 2 usb port.. can I cut cabels of light and merge to usb and plug in modulator ?
If you divide the watts by the voltage that gives you the amps under normal operation. so you can select a fuse higher than the design current basically. Watts÷ Volts= Amps For example 5W÷12V=0.41A Source: Ohms law baby
Your boost is low for extreme tune and wastegate closed
i just tried & failed miserably, not giving up though just ordered a new set of LEDS😭🗣️
Do you need to use the fuse
would you say it also make the lights brighter or no?
Bro mines new and the red part isn’t even glowing
Question: Do your lights turn on on their own once you turn on the the car? Thanks again!
Are this is the same process on all car I have Chevrolet Tahoe
Hey just to let you know this helped me a lot, I just have a question the led strip is getting really hot after a few minutes, you know why is that the case ? Maybe I put the fuse tap the other way around ? Or since my lights were usb powered they had a blue and red wire and assumes red wire was positive? Lights turn on but they get extremely hot . I tapped it to radio is a 7.5 amp and used a 5 amp fuse for the top. Help please , thank you beforehand
Definitely not 800hp. Be lucky if it’s 500hp. Thing did awful. The burnout on the side of the road sounded like all clutch😂. Mine dynoed at 656rwhp all fuel no tuner and does wayyyyy better than this thing😂 definitely not worth the video watch.
i didn’t get a remote at all
Some come with remote and others dont depends on the brand and model
Dope
My lights are staying on regardless of my car being off or not... I tried the sunroof spot and the radio spot
Car off and they on it means connected to a fuse with constant Power (power without key Ex. interior light (turns with door) or a fuse that powers anything you can turn ON WITHOUT key in general) I suggest connecting to cigarette lighter fuse ( tends to be a number 15 fuse but check your fuse box scheme available on the cover of it)
I think I have the exact same ones does it have and app that claims u can change it to 16 MILLION different colors lol. I wouldn't know who uses the software for any of these 20$ lights I can't imagine they are anything but a glitch filled headache? But if the app does work lemme kno, I'll maybe go through downloading it then. Anyway these light are great I even had them come apart because I was just to rough over the matter of like 3 years and bought new ones not even close to as nice in everyway really and yer right I did indeed lose that fuckin remote. Anyway did some soldering and fixed those ones and used the ir remote from the other set which for some reason was the best part about those strips it was in an aluminum casing super nice looking rounded rectangle metallic black lol smh idk 🤷♂️ why they decided to make only that part about it nice. Anyway re-instlalled these with alien tape and the stick again I ran into the same problem it was my one amd only complaint for these particular strips. Thanks for the fuse wiring kit idea I didn't even think of that I've been using a rocker switch for all my led lights which this seems easier like way easier. Appreciate ya!
Alien tape, Amazon. You’re welcome
Why can't I just plug it in the cigarette space
Srt4 ftw!
Great video man
What if mine does give power even with the key off
floor mats(APC)..wow remember them 🤣🤣🤣🤣
are these really worth doing? they seem really tacky and make the car seem cheesy af. but yeah just wondering
THANK U