Video

Just got the coupe xi awd but it’s automatic with triptronic..this was a great video and I learned a lot bro thanks

How did you fix the front high

Good job , which is better redline or BlueLine ?

man frick i can’t find what to do with the catch can hose

Good info, but I couldn't watch the video, too much moving around, got dizzy watching it.

Great video! Do I have to do all of these steps just to change the oil pan gasket?

Where did you get the new motor at?

If the gasket is defective, can engine oil flow into the coolant auxiliary tank?

Do yo have the links to buy all the parts?

Holy shit this is a nice sound

This happened to my M3 2015 S55 engine, big headache to fix it, worst part is to remove the oil pan and valve cover

I’m confused on how to connect the thermostat. So the driver side oil line you labeled “o” does that connect to “out to engine or in from engine “

Made it look pretty easy wish me luck

Is it possible to swap the motor without pulling the tranny with it?

Im not an expert but I thought these N54 were pretty iffy but yours is killing it. So 👌🏻

Hi Jack, nice vid! Can you let me know why did you choose the plate option instead just the two fitting option keeping the oem thermostat? Thks!

Nifty!!!

Hey, what a great video. Im having some issues with the piping for the rear turbo. It basically sags and dosent sit right did you have the same issue if so what was your solution?

What intake is that holy shit sounds amazing

Is that a 325e radiator

when xdelete is enabled can you run a staggered setup for example rear 17x10 wheel with a 265/40/17r front 19x9 wheel with 235/35/19r

Thanks , Good video how can I find the oil seal : it’s some size with the cam seal

you said your going to show steps of install but you skipped the most impostant part. the inlets.. thumbs down hommie

Best bang for buck for sure. Great video!

Awesome work. It is very detailed enough man. Keep rocking and wrenching man. Thanks for the time. One of the bests xDrive oil pan tacklers out there in the Bimmuh community. Peace ✌️

What’s the part number for the control arms and will it fit and 83 year?

550i f10??

What is the torque spec for the inner case crank pulley bolts? 16:28, you stated that there were 4x size 10m Bolts, and 2x size 13m bolts, by the way not counting the bolts connecting from under the oil pan fyi.

So the car is still on its oem stock twin Mitsubishi turbos?

Nice did not know some thanks for posting

My Rear end is all over the place with the Xdelete. Be careful people!!!!! I have a 2008 335xi coupe with only 90,000 miles on it. Full bolt ons,except upgraded inlets.. Also have a MHD Stage 2+ tune.. the car is very Squirrley with rear wheel drive!!!! Be careful!!!! Be carful!!!!

I have a 2010 335XI. 150,000 miles Dripping on driveway for awhile now. Dreading doing the oil pan gasket. I would be due for the coolant pump and gasket. Should I do new Varga turbos while I'm under there? have you replaced your turbos?

This is old but did front main seal leak looks like it’s pushed in to far ….thought it had to be flush , also did you use the lube primer or glue that needed for it?

Hi man, i have a question Where did you connect wires from park light ( turn signal light ) Thank you man

Great video

what exhaust setup

Any downside for not having oil thermostat?

Hey man I had a question about one of your older videos, in regards to the 335i drive. Where did you find that carbon fiber trunk, I hate the bulky look on my 528i and I’m trying to find something that will look my rear a lil better

Hey man I know I’m late but where did you get that trunk for the X drive? I hate the bulky looking so I’m trying to find something a little more sporty for my 528i

ST n55 makes 440 😭😭😭

Does this void BMW extended warranty? I wanna do it on my 440i xDrive but am worried that it might void warranty D:

Can anyone help me out my 07 328i has a rough idle when starting and either smooths out or stalls out i think either fuel pump or air mass sensor but I’d love an opinion from another bmw driver

Custom tuned or mhd?

that's crazy too that you got those number to the wheels on an X drive car with more drive train loss

I'm in the middle of this job right now...I thought about killing myself, but my gun was in the kitchen in my holster.

So, the only things on the exhaust are the secondary cats? Other than that it’s just straight pipes?

Looks like an e92 to me.

could the rear inlet be blocked off?

8:16 So what happened? What was the problem there? Yea the torque from the OEM turbos is always really awesome! That's one of the great things about this engines and cars that you can really feel that low down torque when you hit the throttle and it just pushes you back in the seat like a sling shot! SWEET!!