Video

God bless you! Amazing, thank you so much. ❤❤❤

That was a brilliant little preface about spacetime! Ha ha!

Fixed in 2 minutes

Thank you sooooo mich

Thank you so much.. It worked on my 2010 Equinox

Good idea

Going home to try this now

Really working now. Thanks a lot!!!!

My 2009 had same problem and after i followed your instructions my car got fixed BUT the next day it went back to old position. Should i repeat ?

My 2009 has two batteries. Do both need to be removed at same time ?

You're a champion mate, worked for me :)

Great video, ive got the same bleeder I use on a few cars which works a treat, however on my Freelander 2 it never works...get it up to pressure , crack the bleeder screw but no fluid or air comes out...strange one as it works on other vehicles.. end up having to do it the two person method...always wondered if its something to do with the abs pump or something

Wow nice! Clever and good-looking build with the side kitchen.

Wtf😂 i was just watching video and just hold for 25seconds and it works❤thanks

Thank you so very much!!!

Did your Discovery also have a F for restricted gears ? I have a Range Rover sport 2,7 v6 TD from 2007 with the same faults

Do you have a video showing the replacement of the entire drain mine has separated from the top and the lower end has separated from the air intake area

I didn't know that. Thanks for sharing. Cheers.

It works!! Thank you!!

the brick wall hited u :))))

Does it works with all the cars my cars sunroof not being closed fully

Amazing!!! thank you so much

hiya what program are you using

Wow, it worked perfect on my LS 400. Thank you 🙏

Didn’t work for us. Sunroof was open - it will close part way and then back to open. Darn. I was hoping!

Grazie per il consiglio, grazie a te ho risolto il problema 💪🏻

Worst truck ever!!!!! I have 2 with the same problem one 2008 and one 2016

Well done, mate! Thanks from Merritt Island, Florida.

Big bro thank you so much trick worked on a 2013 autobiography north American model.…. Big ups for this guy.

Saved me a life of anguish man thanks! Worked!

My brother thank you so much. I watched a few videos that we’re gonna have me try to replace the motor or something. In my 1999 Toyota Land Cruiser I just hold them for 20 seconds and immediately closed and curiosity got the best of me so I tried to open it again and it fully opened fully closed. Not sure why maybe it was really cold here in the southern USA. Thanks again my friend.🇺🇸

This did the trick, thanks for posting

Fantastic video. Thorough and clear.

Promo`SM 😑

Vinyl

Thank you for posting this. It actually worked on my 03 4Runner. I had the headliner out an found nothing jammed in track. Thank you again.

Hi , been following this on the D3 forum, looks an amazing modification that ur doing , thks so much for sharing this with us and looking forward to the progress , may I also add a very happy 2024 , Gary

Hi thanks for the video. Quick q if you don’t mind… when the fault came up was the car sitting lower than normal? And when you did the reset did the compressor kick in and pump the car back up to normal height? Been going through these issues replaced the computer and the compressor and still have this fault and the car is sitting too low… any advice appreciated 😊👍🏼

It worked thank you

Just to make one point and that is about the fuse rating to be chosen to piggyback onto. If you fit the fuse adaptor in the right way round the accessory being connected does not draw power through the original fuse, if installed the wrong way round it will. When the circuit is chosen turn the car on and make sure the device in question is working, then remove the fuse and check that it no longer works. Install the fuse adaptor with only the accessory fuse installed and check if there is 12v on the flying lead that will go to the accessory. If there is power then it is the right way round, if not then pull it out and test with it plugged in the other way round. Then you can install the donor fuse back in the socket nearest the fuse board to make sure the vehicle works as necessary.

Bro you save my life on this One , thanks a lot !!!

thanks for that I will try it now - ps no way did that sunroof seal! they rely on the drain tubes to drain the water down a and b pillars

The sr module has an anti trap feature. The system knows how many revolutions of it's drive motor must go before the closing voltage /current spike occurs when the close position is reached. If it encounters a spike B4 that that number of revolutions is reached it will stop and retract. This is the law in US. Reset procedures vary by make. Essentially you are making the sr module computer relearn the true open and close positions

How did you know to reset the steering ?

Better take the disco rather than stop to charge

Its eye eye D

Thanks you, mine did the same thing and that fixed it

Well spoken thanks!

Thank you it worked! Forgot to close mine, and it rained and got stuck. Brilliant 🎉

Thanks!