SYIL X4 CNC Mill Teknic Clearpath SDSK Centroid Acorn Project: Bench Testing
Vložit
- čas přidán 16. 02. 2021
- 3/11/21: ADDED: Move the C86ACCP Jumpers to 1-2 SOFT ENABLE. This will allow resetting of the Clearpath motors should they fault by cycling the Estop button. Servo motor rotors will not lock until CNC12 is in the READY state.
Stay Up to date by following my build thread on the Centroid User's Forum: centroidcncforum.com/viewtopi...
I go over connecting all the Teknic Clearpath components, Acorn, C86ACCP interface board and setting up CNC12 for the basic bench test of the system.
Links/Videos:
Clearpath SD Overview: • ClearPath-SD (Step and...
Clearpath SD Fractional Accessories: • ClearPath SD Servo Fra...
Clearpath Integrated Servo Motor Video discusses SDSK and SDHP along with demonstrating stalling a stepper motor (open loop) vs. "trying" to stall an SD Motor: • Watch a ClearPath Inte...
Clearpath SDSK Installation Manual: www.teknic.com/files/download...
Centroid Acorn: www.centroidcnc.com/centroid_...
CNC4PC.com C86ACCP: www.cnc4pc.com/c86accp-clearp...
Nice work Marty, The CNC4PC boards are a real time saver. Really good explanation and demo
Thank you Marty! Followed this guide and got my ClearPath servos working properly! Excellent demonstration!
Hi Marty a good short and accurate video of setting up and connecting Acorn and Clearpath, and thanks for your support. keep up the good work from Poul in Denmark :-)
This is a timely series...Am about to build an Acorn/Clearpath motion system.
Very nice instrucional video, Thanks Marty
Good demo Marty! Say... how much money you you think it's on that table? Ciao, Marco.
Did you configure the sdsk's high level outputs to monitor for drive ready/ drive fault? I am a little confused by this on my setup
Does the C86 ACCP provide the pull up resistors required by Teknic? If not, how will you add them?
Hey Marty, thanks for making this video! What’s your thoughts on clear path vs dmm?
I may have set up my mill and lathe incorrectly. I thought the standard SDSK motor resolution was 800 per rev. And the enhanced versions were closer to 6400. They are working, should I change my settings?
My Z axis faults ?
can the input terminals on the acorn receive 24v signal
Hello Marty. I have a question on the C86ACCP. I recently installed the board, the new one with the flying lead terminal blocks. I see in the GCnC Revisions manual that you have wire jumpers in the two position flying lead blocks. Are these necessary when using the molex plugs. I ask because I seem to have to have input 5 set to NO red circle. If set to NC drive fault occurs upon any movement. I wired everything else as per your video.
Hey Marty, if i have the relay output 1 occupied by my e-stop contractor circuit, can i leave the red jumper that comes with the c86 board in there? Do i need to move the acorn enable jumper to on?
I don’t see a “no fault out” option for outputs
What is HFLB ?
Are teknic servos same as clearpath ?