My Trailer Setup & Mods for Pelican Bass Raider 10e

I took a run-of-the-mill jon boat trailer and modified it to work with my Pelican Bass Raider 10e NXT. I walk you through what I did with video and pictures and demonstrate how I launch and load the Bass Raider by myself.
#bassfishing
#pelicankayak
#bassboat

[@monzsterman]

Nice set up. I ended up buying a utility trailer for my Quest 10 but wish it had a longer tongue like yours. I've had some struggles but it's getting there plus the utility trailer does come in handy when moving things. Another nice video sir!

[@yakkittymack]

That is the positive side of a utility trailer for sure. I seriously considered going that route on my kayak trailer but opted for a jet ski trailer instead. Thank you for watching and the kind words @monzsterman

[@SkunkMasterFishing]

Awesome, great vid and informative! Thanks for sharing!

[@yakkittymack]

Thank you for the positive vibes @SkunkMasterFishing

[@babboa88]

I would be afraid the corners of the plywood that are not supported or tied to anything would warp either up or down. As long as that doesn't happen, it looks good.

[@yakkittymack]

@babboa88 thank you for watching and commenting. You are 💯 percent correct about the warping. It's only a little bit so far and they are bending downward, so I am going to add support to that end. Having never done anything like that before, I never even considered that a possibility. Thanks again and tight lines!

[@richardkeller6940]

Thanks

[@yakkittymack]

You are welcome @richardkeller6940. I hope it was of some value.

[@phatpakbaits]

Can the boat fit into the back of a truck? is it too wide?