I know this is a little old, but THANK YOU!! I own a manual Mitutoyo and learning this on my own via there self help books is like going to the dentist without lidocaine. I know this sounds silly, but it helps me greatly. Especially the coordinate system you did, so much simpler than what the Mitutoyo rep showed me.
If you're gonna dumb it down and use the go to method for every point you might as well add a clearance height. At least then you don't have to worry about the probe crashing into the part.
Sir, you are very informative, but is there any way you can give us better screen shots so we can see the operating software as you describe what to do? Thank you for taking the time to make these informative videos.
It’s really how you go about setting up the program in learn mode. For me, I have never had to switch it. But I don’t run the CMM everyday. I’m sure y’all have ran into issues that I never have ran into.
You're great! Thank you for such informative and straightforward videos.
I know this is a little old, but THANK YOU!! I own a manual Mitutoyo and learning this on my own via there self help books is like going to the dentist without lidocaine. I know this sounds silly, but it helps me greatly. Especially the coordinate system you did, so much simpler than what the Mitutoyo rep showed me.
You’re welcome! As much as I love Mitutoyo products, the instructions could use a little help.
Thanks. Video is so educational.
This video really awsome to learn basic for CMM.
Thank you!
If you're gonna dumb it down and use the go to method for every point you might as well add a clearance height. At least then you don't have to worry about the probe crashing into the part.
Perfect......
Sir, you are very informative, but is there any way you can give us better screen shots so we can see the operating software as you describe what to do? Thank you for taking the time to make these informative videos.
Good
Hi sir,
Can you make videos to alignment step cylinder and cylinder?
Can you explane Mitutoyo manual version 4.3 all tools and programming step by step
How to switch from manual alignment / CNC mode to dedicate alignment ?
It’s really how you go about setting up the program in learn mode. For me, I have never had to switch it. But I don’t run the CMM everyday. I’m sure y’all have ran into issues that I never have ran into.