Rocktol / Mossy Oak 12-in-1 Multitool review and mods

Rocktol 12-in-1 on Amazon: www.amazon.com/dp/B0C7GBPR3Q/
Pretty solid option at $20.
Mods I recommend:
1. Reverse the clip
2. Use adhesives to secure the clip to the pivot screw so it doesn't wiggle
3. Oil the pivots
4. Tight down the knife pivot and secure with threadlocker to limit lock rock
5. Add masking tape to knife hole for one-handed opening
6. Add a 6x2mm magnet in bottom of 1/4" driver for much improved bit retention

[@hankua]

I bought one, and turned round and got another; both Mossy Oak.

[@shawnpatrick1877]

You know what I appreciate about this video? I didn't feel like you were trying to sell me something from a company that sponsored you like many of the "big," channels do. It just seemed like a no BS, honest review.

[@MegaFrank1960]

I "liked" your video bro....lol. You seem pretty knowledgeable about these tools, but more so the entertainment value is good. You'll see as you move forward with these videos, what more you should include, and what crap you could do without. Good luck in future videos, new subscriber here !

[@Rothanware]

Good video man. Was wondering about this tool and I ended up buying it for the same reasons: half the size of a Leatherman and I don't need pliers in my day to day. Thanks for the mod suggestions and looking forward to future vids.

[@xxxy9928]

vossteed should made one !!! in a 70-80bucks range !!!! that thing would rock i bet !!

[@rentman1225]

Thanks for the video. I have both tools and they are nearly identical. I will try your mods. They come with the double ended bit, however the Philips side is #1 Philips. I switched it out for a double ended bit which has a #2 Phillips on one end. I only use the knife blade and screwdriver and would prefer the small and lighter weight Gerber Armbar Slim Drive. However, the Gerber doesn't have a belt clip. Also the bit is similar but doesn't have the ball. It is held by magnet only and I lost the bit when I dropped it while working on a lift. I can't find a replacement bit. I'm going to try to grind off the ball from one of the replacement bits I purchased. If that works I will use the Mossy Oak belt pouch with my Gerber.

[@richardbenvenuti2605]

Ordered and received a mossy oak 12in1 multitool. Upon inspection found the flat drivers to be machined so thin were actually sharp and most likely would bend if used. Going to return. Do all of these 12 in 1 multitools have the same problem? Anyone have same experience????

[@DirksDirks]

@@richardbenvenuti2605 I haven't bent mine but it does seem sharp. That said, you could just use it as a scraper and leave the flathead screwdriver job to the bit driver. As it ships, it comes with "two" flathead screwdrivers.