Rocktol ST02 knife multitool unboxing/overview/tests
Vložit
- čas přidán 9. 04. 2024
- This is a nice EDC tool. Half knife, half multitool! There are all the necessary tools. Blade and scissors cuts, screwdriver turns, opener opens cans and bottles of cold beer. 😏 Good! Compact size and weight. Convenient to use.
The only minuses are that the bit driver does not have a real lock, and there is no magnet inside, so it does not hold ordinary bits... and the blade steel could be of a slightly higher class. Everything else is good in my eyes!
Rocktol ST02 ➡️ www.rocktol.com/products/rock...
a.aliexpress.com/_Ew1yplV
@ROCKTOLTOOLS
#knifeunboxing
#budgetfriendlyknives
#multitool
This is a nice EDC tool. Half knife, half multitool! There are all the necessary tools. Blade and scissors cuts, screwdriver turns, opener opens cans and bottles of cold beer. 😏 Good! Compact size and weight. Convenient to use.
The only minuses are that the bit driver does not have a real lock, and there is no magnet inside, so it does not hold ordinary bits... and the blade steel could be of a slightly higher class. Everything else is good in my eyes!
Rocktol ST02 ➡️ www.rocktol.com/products/rocktol-folding-pocket-knife-12-in-1-stainless-steel-multitool-knife-with-titanium-plated-handle-pocket-clip-for-camping-hiking-survival-men
a.aliexpress.com/_Ew1yplV
Nice video! Apparently, a 6x3mm or 6x2mm magnet in the bit driver will stay without glue, and will allow retention of double-sided bits.
I bought mine last week.
Au top ce multitool 😀👍
Very good video, and super knive and tool, i have one question: where have you your extender with detent ball? Sorry for my English, i'm french. Very nice video. Thank you and see you later 🥰🙋
2 times longer than a SAK swiss army knife. That opener piece is on the wrong side , you put it in the other side and the knife gets jn the way. Check out the SAK in a shop, the can opener take a photo of it . Have proven the original Letherman can opener to be opposite hand to the task as well . That little finger grabs under the rim of the can and you lift the knife for the blade to cut under force if your grab from the little finger & and move in the opposite direction, blade leading and knife body following 😊
Do you think this could be modded to remove the blade and use a Leatherman Diamond file?
Rocktol will send you a diamond file blade, though it won't fit where the knife is, you might have to swap it with the scissors. Their detent hole is on the opposite side.
On mine, deploying the smaller tools is extremely difficult. That whole section is so tight, I'm wrecking my nails just trying to get them out. Even then, they all stick together. Does this loosen up over time?
Maybe the axial bolt is overtightened in your version? Try to unscrew it just a tiny bit. And yes, tools start to move more smoothly with time
Eek. The bolts are so tight they started stripping. I have have to send it back.
@@mtlreiner loosen the screw 10-20°
@@xxxy9928 Tried that. Too tight. Started stripping the bolts. Returned.
wish they made a thin version witout a scissor but a good file and 4mm bit