Machine Guide 7 | Plotter Pen

In this video,you can learn how to use the plotter pen,how to set parameters in Lightburn,how to shorten the time of pen moving up and down.
Please make sure that you [Enable Z axis] and close [Optimize Z Moves] in Lightburn Device Settings-Z Control.
Comment below to let us know if those videos are helpful,thanks!
NEJE Max 4:
neje.shop/prod...
🔗For more products:
neje.shop/
🔗Get NEJE ideas:
nejetool.com/
🔗Join our FB group :
/ neje.shop

[@doriankoelmans8287]

I see the pen moves up and down between lines... I can't seem to figure out how the pen behaves. with a simples drawing; 3 lines next to eachoter spaced about 2 mm apart, the pen stays down inbetween lines, so it drags from one point to another. So the pen always stays down. Is this a setting i'm missing or does the pen move up and down randomly?

[@nejestudio686]

Hi，
Please check whether Enable Z axis and Relative Z moves only are turned on. If the problem still cannot be solved after turning them on, please join the Facebook group NEJE_Laser. Our staff will answer your questions at any time.

[@benjiz26]

Great response time again! 👍
It is a bit confusing sometimes for me if it is 0 or O ... works often better if you use the right one!
By the way when is the CNC spindel coming for the Max4? Should be easy to just add a 500W motor just like for example a knife or pencil.

[@nejestudio686]

We should mention it is a 'zero',nice feedback,thank you benjiz:D
I haven't heard when will the CNC spindel come,we will keep you updated in our FB group.And I already see some laser friends use a hard tip to engrave on metal lol...