How to Replace Inner Tie Rod 2009-2014 Ford F-150

Buy Now!
New Tie Rod from 1AAuto.com 1aau.to/ib/1ASTE00732
This video shows you how to replace the inner tie rods on your 2009-2014 Ford F-150. The inner tie rod has a ball joint that can wear over time, causing a clunking noise, loose steering, and eventually, other problems with the wheel and suspension components. It’s a good idea to replace your inner tie rods as soon as you notice any of these symptoms.
This process should be similar on the following vehicles:
2009 Ford F-150
2010 Ford F-150
2011 Ford F-150
2012 Ford F-150
2013 Ford F-150
2014 Ford F-150
Tools you will need:
• Pry Bar 1aau.to/oU9/1AXAA00020
• 15mm Wrench 1aau.to/oXm/1AXAA00010
• 24mm Wrench
• 21mm Socket 1aau.to/oajw/1AXAA00043
• 24mm Socket
• Needle nose pliers 1aau.to/oD6/1AXAA00051
• Needle nose pliers 1aau.to/oD6/1AXAA00052
• Pliers
• 1/2 Inch Impact Gun 1aau.to/otN/1AXAA00252
• Torque Wrench 1aau.to/oaHW/1AXAA00044
• Anti-Seize Grease
• Gloves 1aau.to/oadh/1AXSS00048
• Safety Glasses 1aau.to/o6p/1AXAA00343
• Wire Ties
• Floor Jack 1aau.to/o7Q/1AXAA00068
• Hammer 1aau.to/oU8/1AXAA00091
• Jack Stands 1aau.to/oVx/1AXAA00065
• Rubber Mallet 1aau.to/ogY/1AXAA00413
• Wheel Chocks
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@erikgriffin5193]

I could flip a table after how you bent that cotter pin......

[@boujeenative5868]

Thanks !

[@LuisitoCrypto]

Omg you hit the rotor with the hammer, be more careful my man 😅