Video není dostupné.
Omlouváme se.

PC800 Carb cleaned road test May 2022

Sdílet
Vložit
  • čas přidán 16. 05. 2022
  • Earlier, I drained the float bowls, removed all the vaccuum and fuel lines, and flushed the carb with Berryman's B-12 aersol carb cleaner. Then I ran the engine with a high concentration of the cleaner in the gas, and sprayed it into every available orofice while it "ran". This bike will barely run with the airbox off., but you can force it. Then the bike sat for a few months, while it rained, and I did other things. About 6 weeks ago.. I faked together all the tubes, set the air box on top... and ran the bike a few minutes.
    Today, I made sure all the tubes were in place and properly secured, replaced the airbox and filter, and fired it up. After it idled awhile.. I backed it out of the motorworkshop...let it warm up, put on my gear and took it for a 20 minute ride. GOOD NEWS ! the flat spot in the throttle response between 3600 and 4000 is nearly gone.. and no longer troublesome. Previously I worked pretty hard to get the carbs as well balance as I could. So, next step will be to finish the other "garage queen" service.. new fork and brake fluids, control and chassis lube, and more riding to break in the brand new tires. Back in the motorcycle riding business !

Komentáře • 14

  • @philliplee2036
    @philliplee2036 Před 2 lety

    Glad you are still around. Just picked up a barn find 94 PC800. It sat neglected for 12 years so there is allot to go through. It starts if fed fuel through the throats. Carb rebuilds are a must. Bike is stripped of plastics to reconditioned and repair. Lost of work. Started a thread on the tapatalk pc800 forum to follow along with the restore. Plus considering starting my own CZcams channel. No experience and full time job so dont know that I'll post much content. Keep the videos coming this is awesome there is not a lot of content for these bikes on CZcams so every video is awesome.

    • @captlarry-3525
      @captlarry-3525  Před 2 lety

      ok. yeah if it wont run at all carbs out is on your plate make sure the vacuum fuel valve is working.. you can drain and flush the float bowls with the carbs in... and run a bunch of spray cleaner through them too... make sure there isnt any gunk in your tank.. thats a long time sitting. any rust is an indication to remove, clean, etch, and coat your tank. No bike will ever run right with rust in the fuel..and no filter will get it out.

    • @philliplee2036
      @philliplee2036 Před 2 lety

      Carbs are off diaphragms are damaged waiting on new ones

  • @ernestosantos4282
    @ernestosantos4282 Před 10 měsíci

    Muy buenas motos

  • @user-hy8md7pg2v
    @user-hy8md7pg2v Před rokem

    Hi, have a 1990 and haven't been riding over 1.5 yr now, decided to check the spark plugs and air filter. Replaced both and noticed the air filter box is not sitting right on the carbs! The front of both rubber flanges stay up! So disappointed with this stupid design!
    Bike is only srarts running when I control the air flow with my hand on top of the throttle holes! Should I get the carbs fully disassembled and cleaned? Also meant to add when it runs with my hand boost! it spits lightning shouts out through the exhaust. Tx

  • @cesaralejandrosanchez9496

    Será compatible ese carburadores para una honda vt 800cc

  • @trialsbikeguy
    @trialsbikeguy Před rokem

    Just bought a 89 PC800 ..Beautiful bike 1 owner 28,000 mi. The previous owner did park it over a covered shed but on dirt ground .soooo now I have rust underneath. I need advise...my muffler is loud because there are rusted holes in the rear part of muffler. How much of a pain is it to replace ??

  • @user-hy8md7pg2v
    @user-hy8md7pg2v Před rokem

    Has anybody ever repaired the stator of these bikes? Mine is not charging the battery

    • @captlarry-3525
      @captlarry-3525  Před rokem

      yes of course they have. Find the PC800 owners group on line, and then look in the extensive archives, for almost any kind of repair article. I believe there is an upgrade using the stator off another Honda model. Also some info on rewinding the coils,which isn't brain surgery.

  • @facugodoy8822
    @facugodoy8822 Před rokem

    Hi! I have a 89 pc800 and lately ive done a carb rebuild, when i finished rebuilding it i started up and i noticed that from the little valve where the carbs takes fuel from, there ir a little tube facing downwards that spits a little of fuel, i dont know if there is supposed to be a hose there going down since i bought it second hand. Can you help me confirming if the hose is needed? Thank you in advance

    • @captlarry-3525
      @captlarry-3525  Před rokem

      download the manual on line.

    • @captlarry-3525
      @captlarry-3525  Před rokem +1

      look at my videos.. it is a stock california motorcycle.

    • @cesaralejandrosanchez9496
      @cesaralejandrosanchez9496 Před rokem

      @@captlarry-3525 buenos días amigo necesito ayuda ese carburadores serán compatibles para una honda vt 800cc

  • @captlarry-3525
    @captlarry-3525  Před 2 lety

    NO! There is NOT a K and N air filter in there . Got rid of that POS right away !