@@raylidell3613 I typically find the kits on Amazon or eBay. If all you need is the diagram you can search “ruixing diaphragm” on Google and you should get a ton of hits.
It can be a lot of things depending on what it takes to get it started when it is hot. In some cases a worn trimmer will lose compression when it gets hot. It will continue to run until you shut it off and then cannot be started again until it cools. If holding the throttle wide open helps then it may be flooding due to a stiff carburetor diaphragm. If choking it helps is could be going lean due to the same diaphragm problem. In some cases it's just carb adjustment although typically when they start to need adjusting it's because the diaphragm is staring to stiffen up. What do you have to do to get it to start when it is hot?
Never replaced a duck bill valve before. Nice explanation!
Very cool, I’m glad the video was helpful.
Good video. Any Idea where I can get the carb rebuild parts for the Ruxing carb?
@@raylidell3613 I typically find the kits on Amazon or eBay. If all you need is the diagram you can search “ruixing diaphragm” on Google and you should get a ton of hits.
@@MEGMotors972 Thanks!
Nothing is worse than a hyper tough. Those trimmers are just terrible
My weed eater is very hard to start when it is hot what could it be
It can be a lot of things depending on what it takes to get it started when it is hot. In some cases a worn trimmer will lose compression when it gets hot. It will continue to run until you shut it off and then cannot be started again until it cools. If holding the throttle wide open helps then it may be flooding due to a stiff carburetor diaphragm. If choking it helps is could be going lean due to the same diaphragm problem. In some cases it's just carb adjustment although typically when they start to need adjusting it's because the diaphragm is staring to stiffen up.
What do you have to do to get it to start when it is hot?
@@MEGMotors972 let it cool for a little while. Cantankerous machine
@@brianbirtcher431 that sounds like a compression problem. Does it feel like it has good compression when it doesn’t want to start?
@@MEGMotors972 I'm getting old I think I'm going to let the two strokes go and go to lithium