Telescopic Gauges VS Dial Bore Gauges
Vložit
- čas přidán 11. 07. 2021
- Lots of mixed opinions on telescopic gauges. I hope this video opens up discussion in the comments section below.
TOOLS I USE:
Stens 750-120 Carburetor Adjustment Tools- amzn.to/4atkBV5
Engine Tachometer - amzn.to/3TE48GZ
Forceps - amzn.to/4a2ud9v
Zoom Oil Bottles - amzn.to/3TWZV2t
Mityvac Compression Tester - amzn.to/4aimaFS
Mityvac Pressure & Vacuum Tester - amzn.to/3vysI3V
Vessel Screw Drivers - amzn.to/3ISewG2
Bondhus Hex Keys - amzn.to/3J2m8FL
Klein MM400 multimeter - amzn.to/3PI3Y02
Stahlwille Combination Spanners - amzn.to/3IY6fQI
Milwaukee 12v Impact Driver - amzn.to/3VEuxH4
Milwaukee 12v Impact Wrench - amzn.to/4aPESVd
Milwaukee 12v 90 degree Grinder - amzn.to/4czLiJp
No-spill gas can - amzn.to/3TDfWcb
Any links to products are likely to affiliate links and I may earn a small commission from qualifying purchases with no additional costs to you. Thank you!
#smallenginerepair #workshop #service #enginerepair #mitutoyo #telescopicgauges
Awesome man, proven that this method is probably as good as it gets, I’m new at these and your video was indispensable, thanks
Pleased to hear it mate :) lots of people
discredit them because they haven’t put the time in to get use to them, but when you do, they’ll be as accurate if not more so than a dial bore gauge which typically read to 0.01mm where as this set up reads to 0.001!
Your method is a little slower than what I do, though, the results are really excellent, good point mentionning the use of good quality gauges, I know by experience that cheap gauges aren't good for anything.
All in all, you understand quite well the principles of the whole process...
I love the lingo across the Pond, Gudgeon Pin? We say Piston Pin or Wrist Pin. I’ll take a dial bore any day but there are errors using a micrometer to set up a dial bore versus a calibrated ring gage or dial bore setting fixture. Good vid Mate!
Well said mate! Both require accuracy and attention to detail. Thanks for watching and sharing your experience!
i will be buying telescoping gauges based off of this video, thanks!
My pleasure :)
2 things I don't fully understand:
1. How do you find centre so easily? Surely the gauge doesn't want to be perpendicular to the sides of the bore? The springs want to push out and skew the gauge?
2. Not quite sure what you mean when you pull back when tightening the nut at the bottom?
It will automatically search for the widest point. Pivoting the gauge in the bore encourages this.
When I say pull back when tightening the nut it helps maintain friction between the gauge and bore and stops it slipping off and affecting the accuracy of your measurement. It’s just light pressure.
by far the best demonstration available to date, however u forgot to cover the mic markings, now some might tell u were cheating using them :)
@@VintageEngineRepairs correct:)
베어링 내부 공차는 - 값으로 만들어 지는데, +0.003 은 잘못된 측정입니다.
Hey :) I’m sorry I don’t understand
but a dial bore process is a one step .
Not in setup and often only gives you to the .01 of a millimetre.