Staying dehydrated with the Sunlu Filament Dryer Box S2 for 3D Printing
Vložit
- čas přidán 24. 07. 2024
- This version is an upgraded version that has a fan inside of the unit. Previous versions did not have a fan. This was much better.
Timeline
Intro - 0:05
Unboxing - 1:27
Model print review - 6:03
Weighing the filament (698g), plugging in the Unit - 7:09
After 4 hours, weighing filament (696g) - 11:44
The next morning, weighing filament (694g) - 13:28
Timelapse 3D print of model - 14:35
Model print review after drying - 14:58
Conclusion - 15:41
Amazon Affiliate Links
Ender 3 V2: amzn.to/3SaZOQq
Scale: amzn.to/3Q5DmFr
Filament storage box: amzn.to/495EBNB
SUNLU Filament Dryer Box S2: amzn.to/46SPnoM - Věda a technologie
Where is the fan?
Is it blowing the air inside or outside?
It's circulating the air inside
I does you no good to vaporize the water from the filament and not evac it out of the dryer. it will just re-absorb back into the filament remember water has three states - Solid-Liquid-and Gas or (Vapor) You must evac the vapor as the dryer pulls it from the filament other wise it just remains inside the dryer no matter how hot it gets. @@TonysTipBits
True, I end up opening the case once or twice to expell the vapor. That's been sufficient.