Cylinder Honing A Continental O 300 Cylinder
Vložit
- čas přidán 22. 07. 2024
- Cylinder honing a continental O 300 cylinder in our cylinder hone. O 300 cylinders are one of the smaller bore cylinders that we work on in the shop. In this video you will see the process that goes into working on these cylinders.
Check us out online and on instagram :
www.alaskaaircraftcylinders.com
/ akcylinders
We hope you enjoy our videos, thanks for watching!
We are a small aircraft engine overhaul and machine shop located in Wasilla, Alaska.
***This video is meant for entertainment purposes only and should not be used as a guide. You must be a certified mechanic to perform this operation following only the applicable manufacturers instructions. - Auta a dopravní prostředky
Hooked new subscriber. Keep up the good work
A/P IA from San Antonio, Texas
Has anyone ever checked the perpendicularity of the bore to the cylinder flange surface and found it to be off?
Excelente instruction videos, what type of stone used and Grids please
Hello 🖐🏻👍🏻I have seen the video, I think this is good I do with the three-legged burnisher, with pneumatic pressure, what if I want to apprehend is to make the measurement of the barrel of the cylindro, what should I have to do it? And another question after the burnisher I must pass some special sandpaper, because the face of the cylindro is opaque by the friction of the stones of the burnisher, thank you ...
I have a question ,,when you honing for example ,chrome Cylinder do you rechrome it or what
When you hone a. Chrome cylinder do you rechrome that cylinder because chrome will cover about 0.001 let me know please
There are a lot of fault... There are two measurements point for cylinder max wideness.. And also where is your measurement tools calibre tag ? Which authority authorized you ?
When you hone a Nitride cylinder what happen with the 0.010 on the know the nitrate
What model machine is that? shes beautiful
please republish without the background music
That doesn't account for a choked cylinder. How do you hone a choked cylinder?
Hello! Good question. Honing process for a choked cylinder is actually the same! Choke is only a few thousandths so the stones will be a little tighter in the choked area of the bore, but honing doesn’t take very much anyway. When we BORE the cylinder we can adjust the stroke of the stones so we can get a different dimension at different depths. Thanks for watching 👍🏻
What is honning?
Honing is a process of conditioning the surface of the cylinder wall to help with lubrication of the piston rings during operation. Honing creates fine crosshatch imperfections on the surface of the cylinder bore. You can think of these imperfections as peaks and valleys in the surface of the metal.
@@akcylinders Are these brand new cylinders? Are they honed from the factory?
Music during narration is far too loud.