Webasto SmarTemp 3.0 Digital Controller Overview
Vložit
- čas přidán 21. 07. 2024
- In this short video we take a look at the SmarTemp 3.0 Digital Controller for Webasto air heaters. This controller replaces the older 2.0 version of the SmarTemp and was released in 2022. The 3.0 adds Bluetooth connectivity that can be paired with a free Android or iOS app.
The SmarTemp 3.0 Controller can be purchased from our store:
www.vanlifeoutfitters.com/sto...
And is also available with heaters in our various Webasto kits:
www.vanlifeoutfitters.com/cat...
You may also be interested in our Webasto Air Top 2000 STC vs. EVO 40 comparison video:
• Webasto Air Top 2000 S...
Or our installation tips & tricks video:
• Webasto Noise Reductio... - Auta a dopravní prostředky
What I am REALLY wondering is why Wabasto has not integrated altitude adjustment into this controller?
How about showing the differences/added timer options vs. the ST 2.0?
Could you please show,how it work with coolant heater on semi?
I'm having hard time setting timer on phone.
My Webesto on the Patriot camper seems to have a max run time of only 2 hours and then it cuts off and the blower starts blowing cold air. Is there a fix for this?
Does the 3.0 allow us to control the FAN SPEED? Specifically, keep it from ramping up to "AIRPLANE ENGINE" volume mode when the diff. in thermostat to ambient temp is more than about 7 degrees? It's impossible to sleep when the FULL BLAST fan comes on, but we can't find a way to sit ramping speed, threshold, or reduce the max speed (we'd rather it take a bit longer to heat up and be able to get some sleep!)
Also, can we perform a "Soft Reset" from the bluetooth (without having to take the unit apart, jump breakers, etc. )?
Does it allow us to set a 7 day temperature based schedule (eg, at night turn down to 60ºF, but an hour before morning awakening turn up to 70º, and then turn down to 65º during the day)? OR is it just five "Turn On/Off" times (with no temps), which themselves get cleared out each time the unit is powered off?
Lastly, for Airtop 55, can we 1) see/set offsets for higher altitudes (eg, 8,000ft+)? And can we see when it performs "Auto Carbon Burn Offs" as a result? THANKS!
Hi Harry, if I understand your question correctly, I think the answer is "no", you can't use the SmarTemp to control the fan speeds during heating.
As far as , we can tell the smartemp 3.0 has the worst temperature sensor known to mankind. It senses wildly various numbers, so the system only works if you tend to it, like a Shepard. Never the same setting will work from day to day. So, basically useless and expensive