BMW E46 320d 330d glow plug controller unit replacement
Vložit
- čas přidán 21. 03. 2019
- I have decided to replace my glow plug control unit after a long time ignoring this diagnostic error on E46. Replacement is straight forward with basic tool and it takes less than 30min. include reinforcement plate removal...
what's glow plugs preheating control unit does?
====================================================
It helps preheat glow plugs for certain amount of time so that the car can smoothly start and helps reduce smoke emissions and slightly improve MPG.
After engine starts preheating control unit continue powering glow plugs for 2-3min. to help with cold engine combustion process for a smooth run.
Symptoms of bad glow plugs preheating control unit
=====================================================
Sometimes there are not any symptoms at all, everything works fine even at the cold weather until one day the car start smoking during the engine start, little rough idle but after while it runs smooth, then next time you start the car and for some reason the battery doesn't have enough power and its finished with difficulties to start the engine to no start at all.
why the glow plugs preheating control unit go bad:
====================================================
There a few different reasons for the damage of this control unit. On our E46's is mostly because of the fitted location, imagine control unit connected to the vibrating diesel engine block under the car 10-15" from the road surface at any weather or road conditions, Even that unit is sealed the circuit board inside control unit uses very thin wiring connections and it is covered in silicone filament inside the box, but after the years of the abuse of this control unit wiring loose connections inside the circuit board or get burned by short circuit during the vibration on already damaged connections. Second reason are impatient drivers which doesn't want to wait a few seconds till' the glow plug dashboard light goes away and start the engine anyway or keep restarting engine without waiting. - Auta a dopravní prostředky
This is what i like " Straight to point" no waffling and very informative and precise - thanks you for the instructions and video 💯
Very nice instructional video! I have to do the job myself now
Brilliant helpful video. Will do mine soon!
Excellent!
Brilliant thanks
Hello Im having a hard time finding this module on my 318d do you know by any chance where is it?
Bmw x3 e83 2.0d same?? Tnks
hi, on cold weather my e46 starts hard. i changed the glow plugs and im not sure if the unit control is faulty. diagnostic shows no errors and on the plug wire i get 2.5 V. is that normal or should i get 12V?
On E46 M47 engines and M57 are used 5V glow plugs, voltage on the glow plugs is regulated by glow plugs control unit which changing and adjusting voltag during preheating before start, during the driving etc, on our cars glow plugs are not only used for engine preheating... 2.5V is a bit low, but not that far from 5V.
Hi, how long will this take from start to finish please? I got the error code so need to do this soon.
Around 30min. with undercar cover/alluminium support removal. 👍
This can be swapped out from above in 5 minutes
Not with this engine
in the e90 m47 it will not work risky
e46 320d 110kw M47D20 2004 - useless remove right wheel, useless work thank you. Useless remove any wheel. Unit is under LEFT side car (on right is exhaust).
Wheel or any wheels does not have to be removed, it was subtitled right at that moment with "wheels does not have to be removed.. As i was working on brakes at that time i needed wheels removed. Wish you all the best. 👍