2013 nissan sentra with cvt Please support my channel thru Patreon : www.patreon.com/user?u=11026480 Shop using my amazon link to support the channel: www.amazon.com/shop/pnyprepper
Thanks for sharing. I’ve never used an axle puller. You have to get up underneath the car with a big hammer and chisel and whack the old axle near the hub and it usually pops right out. You’re right about the reinstall, getting the new axle in with the clip can be tedious. Be careful not to damage the seal. It’s a good practice to replace it but I usually don’t
7:08 hello my friend. Is permatex white lithium grease alright to use? What type of grease in general? Thank you so much for this video. Nissan sentra 2014 video specific videos are hard to find
Thanks for sharing. I’ve never used an axle puller. You have to get up underneath the car with a big hammer and chisel and whack the old axle near the hub and it usually pops right out. You’re right about the reinstall, getting the new axle in with the clip can be tedious. Be careful not to damage the seal. It’s a good practice to replace it but I usually don’t
7:08 hello my friend. Is permatex white lithium grease alright to use? What type of grease in general? Thank you so much for this video. Nissan sentra 2014 video specific videos are hard to find
Put the screw back on the tierod until its even with the bolt than hit that with a mallet
What about the pin had to replace mine last time had 0 guidance
You just needed a good pry bar to get the axle out of the transmission. No need for expensive pullers.
going to be doing this replacement,where would i pry at to remove it,i definitely dont wamt to go buy a puller for a 1 time job.
@@csmooth619er same
@@csmooth619er Pretty much right where it meets the transmission. It doesn't take much usually.
I use a hammer and big chisel
Apply a little pressure and wiggle comes out easy.
No need to disconnect the tie rod
Do you have to refill de fluid transmission?
just top ot. measure or estimate how much you loss