REMESHING screen printing FRAMES!

Sdílet
Vložit
  • čas přidán 22. 08. 2024

Komentáře • 13

  • @13ritam
    @13ritam Před rokem

    This is great, haha. This was the best learning experience on screen printing! Such good vibes from these guys!

  • @jacstrong
    @jacstrong Před rokem +1

    Love it!

  • @Dtag1971
    @Dtag1971 Před 10 měsíci

    Have some 110 on roller frames 40 newtons. The higher mesh... y'all right on da money. 18 to 25 newtons. The pain with the rollers it can be a pain to tune them in the beginning. Looking back I wish I would have went roller frames all the way. The tight mesh can reduce off contact and give some incredible prints.

  • @user-sz2ip2ym1j
    @user-sz2ip2ym1j Před 10 měsíci

    Try using Urethane glue. it holds a lot better at higher tensions, but takes a little longer to cure

  • @johnmorelli6315
    @johnmorelli6315 Před 6 měsíci

    A $600 Newtometer but the $1.69 set of plastic gloves and paper mask elude us. I feel ya bro. We roll the same way. Just gotta go with the flow.

  • @Nakey_Nate
    @Nakey_Nate Před rokem +2

    5:38 easter egg

  • @C1990
    @C1990 Před 8 měsíci

    Can you put tape around the screens between each rescreen so you just remove the tape (and paint with it) rather than going through this scrubbing process?

  • @Eduardo_Badal
    @Eduardo_Badal Před 5 měsíci

    Any pointers for stretching mesh onto curved frames made for skateboards?

  • @user-kc7ru6qp5x
    @user-kc7ru6qp5x Před 10 měsíci

    what clamps are those? I use saati top ten but yours looks much better!!!!

  • @mellyd311
    @mellyd311 Před 9 měsíci

    What mesh count are you guys using???