Nitrofreeze Dry Ice Deburring and Deflashing

UPDATED PHONE NUMBER: [phone] x105
In this video, our Nitrofreeze Technician Dry Ice Deburrs and Deflashes various parts. A small nozzle is used to blast the part with precise dry ice fragments cleaning unwanted burrs and flash.
Learn more about Nitrofreeze Dry Ice Blasting at the below link.
www.nitrofreeze.com/services/d...

[@user-yb5cn3np5q]

I wish dry ice blasting wasn't that expensive.

[@bobbya.5489]

Can this process deburred tool steel E52100 in annealled stage and hardening stage as well?

[@corneleuscaunan136]

Can we use a nozzle size of 5x6mm? thanks

[@bobbya.5489]

Can dry ice clean very small bured on hardening high speed steel(HRC=64Rockwell)?

[@ryantaylor3805]

Hi Bob, yes it can. Want to send samples? Check out here...www.nitrofreeze.com/services/deburring/dry-ice-micro-deburr/

[@PrevostNewbie]

What was the Nozzle Inside Diameter?

[@Nitrofreeze]

+Mike Giboney Thanks for your question. The nozzle used here is an MC31. It has a blast swath of 0.3125" (0.8 cm) which is approximately its ID as well.

[@Vaishnavik14]

How to contact you?

[@corneleuscaunan136]

and blast a burr on a 175 microns thick semiconductor chips?

[@Nitrofreeze]

+Corneleus Caunan Thanks for your question. We have cleaned cavities as small as 150 microns with this shaved ice technology. However, a part that small would require a fixture. Additionally, if the thickness of the burr is similar or greater than that of the part, you are going to have trouble dialing in the parameters to a setting that will deburr without damaging the part.