Update 2024 ULN2003 Transistor Array Operation
Vložit
- čas přidán 7. 08. 2024
- www.bristolwatch.com/ele/uln20...
ULN2003A Darlington Transistor Array with Circuit Examples
Unipolar stepper motor driver using ULN2003 driving PNP Darlington transistors.
Old video • Using the ULN2003A Tra...
Arduino Unipolar Stepper Motor Driver Board with Arduino Code
• Arduino Unipolar Stepp... - Věda a technologie
Thanks mate, very helpful video
Glad it helped
This is very useful content. Thanks for sharing
Very nice sir thanks 👌👍
Most welcome
Thanks for the update. Would be great to see a real example using arduino
I have a video on that and will post it.
@@LewisLoflin great!
Hi, I doubt it when You say, "you can omit connecting the suppressor diodes common pin when not using indictve loads".
I have done exactly that just because of couriosity on my latest clock build.
It was on a high side driver. Anyway.
IF the diodes could be pulled out of the circuit that would work.
By not connecting the common pin to Vcc it makes an OR-gate out ouf the INTERNAL diodes.
Watch the multiplexed outputs simultaniously altering when done on a clock.
The number digits start blinking at the frequency of the seconds LED, fed through the same chip.
I can't say much until I see a schematic of what you did. Connect the diodes to Vcc then. Thanks for the info.
Hi, see my U125D based clock. Initially it had used an integrate high side driver.
The UTC 62783 is suffered from not fully shutting off the unused digits on a multiplexed clock. This results in ghosting on the LED displays.
The Toshiba IC TBD62783AP is said not being suffered from this bad behaviour
But I had none on hand. I replaced the 62783, a counterpart of the well known ULN2803, with a number of discrete transistor drivers.
@@LewisLoflin Works much better.
How can known max input IN(Ampe) ?
It is stated in the spec sheets. I derate max by 25%.