Video není dostupné.
Omlouváme se.

3 Bipolar Transistors in Parallel and Other Issues

Sdílet
Vložit
  • čas přidán 29. 02. 2024
  • 3 parallel transistors for a 20A battery charger constant current source. How DC gain shifts with collector current. www.bristolwatch.com/ccs/LM317...

Komentáře • 13

  • @keithking1985
    @keithking1985 Před 3 měsíci

    Hello Lewis, i just found your channel "again" while looking at circuit schematics online and brought me to your channel. I just subscribed and am happy to see your channel again as i learnt a load of stuff from you when i began learning electronics a few years back..
    THANK YOU FOR SHARING 👍😊🇮🇪

  • @pault6533
    @pault6533 Před 5 měsíci +1

    I found it very interesting that CZcams is now sending me adverts for "bipolar" medicines after viewing your "bipolar" transistor tutorials. Perhaps you should call them "non-unipolar". 😁

  • @sirajhussain791
    @sirajhussain791 Před 5 měsíci

    Nicely explained, better to show very last updated component values in Schematic.
    Thanks

  • @ryanthompson6865
    @ryanthompson6865 Před 5 měsíci

    Would be neat to also do the same things with a mosfets and op amp, later (constant current).

  • @user-nr1wn9qt1m
    @user-nr1wn9qt1m Před 23 dny

    Thanks a lot

  • @BeetleJuice1980
    @BeetleJuice1980 Před 5 měsíci

    What's the max amps lm317 can withstand in this configuration? It might need a heats ink? Also the same for the power fets.
    Can you explain how the lm317 gives the load to the power fets and not taking it by itself?
    Thank you I learn a lot for those examples!

  • @gkdresden
    @gkdresden Před 5 měsíci

    Going to higher collector currents reduces the current gain. But going to higher temperatures increases the current gain again and also reduces the Vbe. So these tendencies partially compensate the current gain as long as you don't overdo it. Of course it is not wise to operate a BJT at junction temperatures of 100 °C or above.

  • @AxelWerner
    @AxelWerner Před 5 měsíci

    Audio is CENTERED this time, but distorted. thus must have been recorded too loud somewhere.

  • @osaidshabbir
    @osaidshabbir Před měsícem

    Hi, man i want to make an h-bridge for arduino but aldo want to control the speed of the motor. There are more questions that i would like to ask about this.

  • @DeeegerD
    @DeeegerD Před 5 měsíci

    Audio volume is good. A bit of distortion as though being over driven somewhat. Otherwise better.

  • @h7qvi
    @h7qvi Před 5 měsíci

    Audio overload a lot