Sweetheart Storm 2.0 & Plus Assembly and Internals
Vložit
- čas přidán 16. 05. 2023
- The video is suited for Sweetheart 2.0 and the Plus version.
This includes replacing the new pusher as well as installing triggers.
It also shows a method to clear the jam.
It also includes a secret message that the new 2.0 Plus will start Pre-ordering later this week. If you do read this, congratulations!
Thanks, everyone for your support and follow us on FB:
FoamworkAdelaide
/ foamworkadelaide
I've finally gotten round to watching this a few times, and I'm so impressed by how compact everything is, everything just seems so tight without feeling flimsy;
- the planetary reduction/connection doubling as a motor mount
- the barrel/cylinder cam doubling as a spring rest
- the plunger doubling as a pusher pick-up to facilitate the separation of the chamber/cock cycle
- the pusher range control is such a good idea, and being able to fit the forward-push spring without holding in the mag
- the body doubling as plunger
Like this thing feels like it's really had a lot of thought put into it. I knew it was good, but not *this* good.
What I can't figure out though, is how the plunger is held in place cocked.
I imagine that at 7:08 that switch in the pink mount detects when the plunger is at the back, but I'm not sure how it's actually subsequently held.
I wanted to guess that it was an electronic control, but surely without some means of reading RPM, there's no way to close it via PWM control over torque? And sure, shorting out the terminals would apply some stopping force, but surely even with the gear reduction we'd see that slider piece twitching, right?
There is a lot to watch.
I will pass your impression on to Yan and answer your questions once I finish despatching the orders,
Thanks a lot!
what is the longest barrel to be used? What is the piston travel and diameter (displacment volume)? Thanks!
the theory number is 106cc. In our test, we have found 400mm this the best barrel for push that FPS number.
So I reckon it is around 80-90cc.
Meanwhile it is compatible for other OD 16mm barrels, Sabre is too thick tho. Worker barrel is fine.
@@FoamworkAdelaide hope they redesign new version to move the sun planet gear offset lower to allow a longer travel. that will increase the upper fps limit in addition to high gear ratio and high torque motor. more expansive for sure as current straight arrangement is cheapest. 300fps should be prefect for this config.
What is the size/dimensions of the four grub screws you install into the pusher to control airflow?
M6. You can use 10mm if you want.
@@FoamworkAdelaide m6 x 10 mm screws?
@@kerry848 yes
@@C4damnyou thanks 👍🏻
what is the difference between the 2.0 and the 2024 version
We are improving parts by parts and you will see more detail from our website ;D
Will the pro model come in Purple? I really hope so.
There is a demand for it, but it really depends on the order quantities for it.
15:11 what size screws that go in?
M6size. I used 10mm ver.
What are the dimensions of the spring?
WD1.8mm OD16mm Length140-160mm ;D
@@FoamworkAdelaide just safe my life there my friend
where can I get the grip from?
It is a AEG motor grip, suitable grips I have founs includes ‘SBR’ or 'Honey badger' grips.