Mpcnc Part 8: Motors, rails and belts
Vložit
- čas přidán 19. 02. 2017
- Go follow me on my Facebook page found here:
/ snow-catz-16. .
********************************************************************
We are installing Motors, Rails and Belts for the MPCNC machine designed by Alted.
The machine can be found here:
www.thingiverse.com/thing:724999 - Věda a technologie
Thanks for the tutorials, helps a lot to understand what goes where.. Murder mounts were giving me trouble.. :)
Thanks so so much . It is so easy and great tutorial.
Thank you for sharing this.
How did you tighten the nuts in the nut trap on the roller? The nut trap does not trap the nuts, so they just spin, and it makes it impossible to use an open ended spanner.
Could you tell me what size wire loom you used? I'm a little concerned I wont be able to get the connectors through if I order the wrong size. I really like the looks of it though. Thanks for your videos - they are really helping with my assembly.
Craig Bennett I think it is 1/2in. But caint remember. You can always pop your connectors off then run the wire through and put them back on. Just make sure you take a picture of the wire order.
You did not add the most important part ... how did you adjust the angle between the 90 degree tube?
sorry, do you solved this problem? i believe i have the same trouble. Thanks.
Murder Mount!?