godsend, i'm gearing up for a rebuild on my motorhome build on an npr, and it's a bit daunting as a home gamer, so it's nice to have some forewarning about what i'm going up against
??? To get to the inner bearing , if the outer bearing is damaged, than you have to at least examine the inner bearing , no ? what's the point of doing half of the bearing ??
Fantastic, finally what I was looking for!!! adjustment and even with the whole lot 👍🏽
Good to hear that !
godsend, i'm gearing up for a rebuild on my motorhome build on an npr, and it's a bit daunting as a home gamer, so it's nice to have some forewarning about what i'm going up against
Thanks ! It's great to hear you found this useful!
My guy 🎉🎉🎉🎉
Good job very clear explanation just wanted to know did you replace inner bearing seal ?? Or not necessary
Yes I've replaced the inner bearing seal , too.
Good
What ton jack stand do you have under there?
@@indiahcrutchfield3215 I am using 10 ton jack.
Ok
Hi mate, how do you know how tight to tighten the bearings.
Hi , it's all towards the end of the video. Thanks for watching..
Torque specs for ISuzu NPR lug nuts is 362 ft lbs but what is the torque for the studs???
One issue is , a lot of torque specs are omitted , even from the workshop manual, and do not exist on "paper" .
why dismount the tire
??? To get to the inner bearing , if the outer bearing is damaged, than you have to at least examine the inner bearing , no ? what's the point of doing half of the bearing ??
Can you tell me the number of the cylinders please
2 cylinders per wheel on all wheels.
@@vidtech2630 Yesterday I was waiting for a mechanic he did not come. I installed the brakes thanks to your video and I even put the wheels
@@odenlaydesircalheepierre5246 Awsome !
Do You also have a video for the installation of hand brakes that are located after the differentil?
@odenlaydesircalheepierre5246 no , I don't, sorry...