Rough Idle??? Try This: Jeep Throttle Body Cleaning
VloĆŸit
- Äas pĆidĂĄn 7. 09. 2024
- Proudly sponsored by Enginetech enginetech.com/
Engine rebuild kit I used on my 4.0L rebuild: amzn.to/2WuNdbu
Throttle Body Cleaner: amzn.to/3nDpjru
Throttle Body Gasket: amzn.to/3aoZ9EX
Throttle Position Sensor: amzn.to/3r9hFHo
Idle Air Control Valve: amzn.to/2K7LHe3
If my videos have helped you save some money , and you would like to give back to the JeepSolid Garage, consider joining my Patreon page!! There's no obligation though. I am happy to help others out, but it does take a lot of my time.
/ jeepsolid
đšâđ§ A few of my favorite tools đ
Pro-Lift 3ton Jack Stand: amzn.to/2RU6rGa
Pro-Lift 6ton Jack Stand: amzn.to/33R9epj
3 Ton Jack: amzn.to/2S5obyJ
Milwaukee 3/8 Cordless Ratchet: amzn.to/39x7WAO
Extendable Socket Wrench: amzn.to/2LJNV2k
1/2" Craftsman Impact Driver. amzn.to/2fTDoTR
24" Breaker Bar: amzn.to/2RnuSNC
Craftsman Torque Wrench: amzn.to/2Wj7JiD
Dewalt 1/4 impact driver: amzn.to/2GYEJ4w
Be sure to get the kit with 2 batteries. You'll be glad you did!
Craftsman 165 Mechanics Tool Set: amzn.to/2GXRlIg
Excellent tool set that will last a lifetime.
Oil filter Wrench: amzn.to/2IbgT9e
Large Capacity Oil Drain Pan: amzn.to/2OjqXjh
Subscribe: / jeepsolid
Follow Me!!
Facebook: / watchjeepsolid
Instagram: / jeepsolid
Twitter: / dale_jeepsolid
Professional business inquires: email me at dale@jeepsolid.com
#jeep #jeepwrangler #jeeprepair
Some of the links provided are affiliate links, where I earn a very very very small commission for directing you to the website. If you make a purchase, it does not increase your cost, but helps me fund my channel. Thanks for watching JeepSolid. I am not a certified mechanic, just a hobbyist who enjoys working on Jeeps.
The shiniest part under the hood. Thanks for the knowledge.
I cleaned the throttle body on my 2000 wj 2 days ago and I immediately went from 13.6 liters per 100kms down to 11.9 liters per 100kms
...did yours have a lot of gunk build up?
I found putting a little Grease like SuperLube, Brake Caliper Grease or anything that won't EAT O-RINGS on the O-ring to the I.A.C. helps it SMOOTHLY go back in. Also make sure you get the I.A.C. pintle housing very clean inside, especially where it meets the chamfer. Ya taking the I.A.C. housing off is a risk if you don't have that gasket, TOTALLY AGREE. GOOD JOB AT LEAST YOU TOOK THE T.B. OFF TO CLEAN, MOST DON'T.
That is a much better place to keep a shovel than where I've been keeping mine just sitting on the back seat
Loved the video used it a couple times today. Thanks for putting these videos out for us.
California smog issues on YJ's? ( '94 -4.0 original owner) Mechanic's & Smog shop can't figure it out. Hint's, tips, advice? Your content is awesome!
Well done again Dale! I plan on doing this exact thing this weekend. Keep up the great work!
Now that you have a shiny part on the engine you have to keep going! lol
So Iâve been having a problem with my jeep. Iâll be driving then the rpms will drop then catch back up and the jeep backfires. Iâm thinking either crank position sensor or cam position sensor. Do you think thatâs right? Thanks! Your videos have done me more help than just about anything. Keep it up!
...in the end, what was your problem? Thanks....
Got a question dale ,could you make a video how to change a steering gearbox I wanna know how to do it right
so wait......u just cleaned the 2 sensors.....0 need to replace?.....correct?..OR NO.....ty......awesomne video......looks BRAND NEW...WOW...I subbed!
Don't you have to readjust the TPS value voltage since you took it out?
Great video, very good job!
Love your vids but i need help. Ive LOOKED everywhere and nothing.i have a 2.5 yj and I'm getting a code 23 ive already relocated it and cleared it and still having it pop up. Ive bought 3 replacements and nothing. Next step ill rebuild the PCM please help
Sometimes it's as simple as the PCV valve. A $7 part clogging your motor.
Have a dumb question. I have a new throttle body for 98 TJ 4.0L but the throttle cable knurl is smaller than whats on the Jeep now, which is a larger size. How do you remove the knurl from the throttle body arm??? Don't want to use a press until I known the proper procedure??
Do you have any advice as to what could cause a sputter/hesitation when I pull out in first gear at low RPMâs?
I have a 94 YJ, 2.5L
What is a possible problem when I'm pushing oil . I want to keep my yj Vin matching
Great video! I recently did a full throttle body removal, cleaning, and installation on my channel if you want to see it. This really is a great way to level out the idle and help the engine run smooth.
love the vids
Good value
I have a 1998 dodge Dakota base model 4 cylinder 5 speed trans replace all sensors on intake and throttle body new fuel regulator my truck has a rough idle auto zone says my ignition switch is bad but I can still drive it started and unlock my steering wheel idk what to do itâs a jeep motor and trans ?????đ
Hi Dale, @JeepSolid I have a question. Why the idle on my 94 YJ stays on 1300 RPM if I already did a complete tune-up, replaced the MAP, IAC, TPS, PCV and grommet.
Thank you!!!
Any tips on replacing the hose for the PCV valve? It was missing when I bought mine.
Boy, I seem to have a number of videos to watch! Somehow I got way behind on watching!!
Is there such a thing as a Nutter Bypass on a 1989 - YJ - 4.2 with an HEI ignition?
Replaced all sensors, the computer caps still uncontrolled(hi/low) idling after engine start for 2-3min. 1992 yj 4.0âŠ
did you have a fix for this? my YJ is now idling high and won't calm down.
Hi great videos,I have a 2007 jeep Cherokee,red lighting bolt flickers,then go away .
So frustrating,no fault is being picked up from the diagnostic test any ideas guyz.
Press wiring into connection socket tight. Ran into this with my jeep jk
How come it doesnt have the MAP sensor on it?
3 am and Iâm wonderingâŠwhatâs up with my â04 Gr Cherokee.
Intermittently, when I put trans in neutral or park, she revs to 1500.I can feel her trying to pull me through stop signs. Any thoughts?
could be quite a few things. MAP, Vacuum leak, PCM, TPS. Just have to start testing things
2021 Jeep Cherokee wouldnât start..wouldnât even try to turn over. Hooked up my reader and got code P2111âŠcleaned my throttle body and still same issue. Any suggestions?? Maybe the sensor in throttle body? Would this stop my jeep from starting or even trying to turn over? Almost seems like dead battery but not sure. Please help!
Throttle body wouldnât stop it from turning over, you have another issue
U was finna comment yhen i wasnt. The only comment i decided on is, It diesnt look like tgis guy answer questions At All.
So, Ha, no comment.
C'Ya
What rims do you have on your jeep
If you have a throttle body spacer will the gasket still be in the same place?
Yes
Does the 4.0 space help any, or wort the money on the 2.5
4.0> anything else.
My '95 yj 4 cylinder has issues starting after it rains. What could possibly be getting wet that would cause that? It turns over but won't fire up. Sputters like crazy if it does start. Distributor? Perhaps you could direct me to a video of a fix?
I would say you're getting condensation inside you're Dist. Cap. Whens the last time you did an ignition tune up ? Like Dist. Cap, wires, plugs, rotor & possibly the coil ?
@@NoWr2Run It's been a while. So you think the distributor is probably the main source of the issue?
@@upthecreekyt YA, You're getting condensation somewhere in the ignition system. Try these 2 things, Fire it up with the hood open in a VERY VERY DARK PLACE & LOOK FOR TINY SPARKS ESCAPING ALONG THE SPARK PLUG WIRES, AROUND THE DIST. & COIL. Also you can get a spray bottle while it's running ( ANY TIME ) & spray the wires & stuff down with some water too see if it start's to miss or not. GOOD LUCK SIR.
Mine is a 4.0 but i had a similar issue i got a new coil and never had the problem since. Not saying thats what u need but they are cheap enough to maybe give it a try!
@@jmac5023 That's why I said about spraying the ignition system down with a spray bottle of water. Or looking at the engine in the dark for spark jumping. He's having problems when it's wet outside, personally I would do a total ignition system tune up if not done in years or many miles.