Hello JLC, I recently bought a MAN TGA 33-360 from the year 2007, it is bodied with a tipper box, I want to weld on the tipper, what should I do? Should the batteries be disconnected and also the switchboard seen in this video to avoid damage from the welder? Thank you very much and greetings from Spain!
Good
Thanks sir this video was helpful hilarious
ang laki ng engine salamat sa pagbahagi ng kaalaman keep more upload enjoy
Watching po now kabayan,,galing mg ayos
Yon pala ang cause of trouble from the crack parts 😢..galing ni doc..
Kay doc willy tau hahahaha
kahit anong makina talaga padi kayang kaya mo talaga gawin. lupit mo talaga padi. ingat lagi jan
Salamat padi
Galing nman
watching at the moment
Lodi ka talaga pagdating sa makina manoy JLC
Malakas sa tsamba manay bles sy
Are these trucks reliable...i am thinking to get a MAN TGL 7.150... But it's very slow
Hello JLC, I recently bought a MAN TGA 33-360 from the year 2007, it is bodied with a tipper box, I want to weld on the tipper, what should I do? Should the batteries be disconnected and also the switchboard seen in this video to avoid damage from the welder? Thank you very much and greetings from Spain!
Hello sir.any welding to be done on the truck must remove the positive and negative battery connection terminals.thank you
@@jlcworkshop Ok, thank you very much!
sobrang init jan kya maari ring epekto ng weather kya mbilis mg crack
Exactly mama tess hehehe
Better late than never
where to get this loom wire
What is the man headbolt torque
Hello sir,
For D20 engine
Cylinder head bolt tightening torque
Step 1 10 nm
Step 2 150nm
Step 3 300nm
Step 4 +90 degrees
Step 5 +90 degrees
@@jlcworkshop thank you sir
Make Diagnostics videos not parts replacing videos ,
Just check in my other videos
Luna ng maray
Hahahaha maganda pag luma ta para dakol masida dakol pwde iupload sa youtube
السلام عليكم عندي شاحنه مان الوقود يرتفع الى درجه الحراره عاليه جدا شكرا لك