Holley Terminator X Install - 1987 Mustang 5.0 w/ TFS Top End
Vložit
- čas přidán 4. 09. 2024
- Installing a Holley Terminator X in Josh's 1987 Mustang. Josh just got done reinstalling the engine with a TFS top end kit.
This install is similar for 1987, 1988, 1989, 1990, 1991, 1992, 1993 Foxbody 5.0 Mustangs.
Move the 12v switched wire to spot 18 in the fuse box. This will give you 12v while the car is cranking
Thanks Donny! Josh actually ended up moving it a few days after this video was recorded and the car has been running great. I will pin your comment though so others see it since what we did in the video is wrong.
wrong ignition wire spot don’t used a fuse get the power from the wire at the conector
I absolutely hate that I have to cut and splice my old wires into the new harness. It truly is not plug and play.
Yep, definitely not plug and play!
Thanks for the video, do you happen to know the part number for the tps connector splice kit ?
Pretty sure its this one: www.holley.com/products/fuel_systems/fuel_injection/wiring_shop/connectors/parts/8172
Might have to buy the pins separate. If you scroll down on that page you will see a "Service Parts" section that has the pins listed.
@@e-dod for sure thank you
I used the tps connector from old harness that way i could replace tps if needed it will just unplug. just an idea.
Much better idea. Is that your car in your profile pic?
Would i be able to use this intake on a 1967 mustang with the 289 and run a terminator x if i get the fox tfi distrubutor too??? Is it possible
I am not sure if this intake and dizzy will fit on a 289. Unfortunately, I am not that familiar with the 289 or 302. I have a 4 banger in my fox 😂. I was just helping out my brother-in-law with installing the ECU since I have a lot of experience with standalone ecu's.
Part number for the Holley Tku
Not sure what you mean by Tku? The actually discontinued this kit though. Not sure why. www.holley.com/products/discontinued_product/parts/550-937F