F3K DLG Destiny - Zálet - Maiden flight
Vložit
- čas přidán 12. 06. 2015
- Videjko z čepice ze záletu - skutečně prvního letu a prvních hodů celouhlíkového házedla s kruhovým hodem od ROmana Plesla - Destiny. Žádné velké výkony, jen první trimování a hledání nastavení.
First flights of my new full-carbon DLG glider Destiny (by ROman Plesl Czech Company). Only first basic trying and triming and looking for radio nad Destiny setup. - Věda a technologie
Very nice plane dont needs motor, bateries etc. Just good arms :)
Thanks
Beautiful plane and a very nice job of piloting.
Way kool man
What is your longest flight time with a DLG?
Nádhera ako sa dostal tak vysoko aj bez motora.
Good to see the Czech airforce and a Spitfire come out to greet the new model:)
Very high performance model by the looks of it. Is it still looking a little nose heavy or was that you horsing the elevator? I have always had a soft spot for gliders but I am currently tied up in the miniquad scene.
You were stalling all the time; it's too tailheavy...
Hello do you know anything about frsky radios and naza lite my quad all it dose is flip over and I know ever thing is right
Paul Antonucci Most likely you have incorrect channel to motor mapping and motor directions. Compare the channel mapping on the Taranis and make sure it matches the mapping the Naza expects. Typically it will be AETR or the Futaba standard
motor1->Ail
motor2->Ele
motor3->Thr
motor4->Rud
FrSky receivers do not have the channels labeled by function only by order.
If the Taranis is set up like a JR/Spectrum with the TAER order you can change the channel order on the Taranis with a long press on the Menu button then a single press of the + button to show the mapping line. Then press Enter and make changes with the + and - buttons. This is a radio level change so it will affect any other models you may have saved. If that is a problem you can also change the connections into the Naza so that the appropriate channel goes to the correct motor.
All of this can also be done using a single SBUS connection except for the wire swapping obviously so you are the forced to set the order in radio menu system as above.
Hope that fixes the issues .
looks like your cg not correct.