Fyi, there is no reason to brace the x axis with the rail on vorons which sit on the side. If anything you should brace the backside not the top. Plus you dont want the extra weight.
With sensor less being in the rear was interfering with the cable chain but thank you for your concern it’s been printing amazing. I’m super happy with how it turned out. I’m not all about speed
Very nice, like the clean wiring.
Congrats on building Voron.
Thank You.
Don't know what I am really looking at as I am just getting involved.. but I admire you ability to build this.
Thank you kind Sir
Trying to decide between a V2.4 or Trident. Thinking 350 plus a ERCFV2. Are you going to add a ERCF to this 2.4?
Fyi, there is no reason to brace the x axis with the rail on vorons which sit on the side. If anything you should brace the backside not the top. Plus you dont want the extra weight.
With sensor less being in the rear was interfering with the cable chain but thank you for your concern it’s been printing amazing. I’m super happy with how it turned out. I’m not all about speed
@gsx8299 you will have the metals expand at different rates, like I said, there is no benefit from bracing the x, only negatives
Very good buid. I'm building one too. I loved the raised bed, how did you make it? Was it a mod or did you design it?
github.com/VoronDesign/VoronUsers/tree/main/printer_mods/xbst_/Bed_Hinge
Thank you for the kind words
Was this a self sourced build?
Yes sir
How did you get the motors so quiet?
A/B are running 48V