Do you have a video on how to assemble the 3 little shift plates? I purchased a rebuilt transmission and the guy who I paid to put it in, made a mess of things.
Peer Plaut The part you are looking for is at the end of this video czcams.com/video/8OQndaPA8mE/video.html and at the beginning of this video czcams.com/video/JJQNI0joqAI/video.html
Triple A Here is an excerpt from my original written guide. “1a. Tool A is manufactured using a 3/4" wooden dowel rod. Cut it to 6 7/8" long. If the dowel rod has a rough finish, it should be sanded smooth and the ends lightly rounded. I did this using a 2" long drywall screw mounted in my drill. I turned on the drill and screwed the screw into the end of the rod, as soon as it snugged up, the rod was spinning nicely. It made sanding very easy. Merl - Make sure you test fit the dowel through the front and rear holes of the case prior to assembling the cluster gear, sanding was required in my case. Also check to insure that the shaft is not too long to fit into the case from the inside. “ I hope this helps.
Thanks sir 👍👍👍
Do you have a video on how to assemble the 3 little shift plates? I purchased a rebuilt transmission and the guy who I paid to put it in, made a mess of things.
Peer Plaut The part you are looking for is at the end of this video
czcams.com/video/8OQndaPA8mE/video.html and at the beginning of this video czcams.com/video/JJQNI0joqAI/video.html
What size was the wooden rods you used for the pilot bearings and reverse idle gear
Triple A Here is an excerpt from my original written guide. “1a. Tool A is manufactured using a 3/4" wooden dowel rod. Cut it to 6 7/8" long. If the dowel rod has a rough finish, it should be sanded smooth and the ends lightly rounded. I did this using a 2" long drywall screw mounted in my drill. I turned on the drill and screwed the screw into the end of the rod, as soon as it snugged up, the rod was spinning nicely. It made sanding very easy.
Merl - Make sure you test fit the dowel through the front and rear holes of the case prior to assembling the cluster gear, sanding was required in my case.
Also check to insure that the shaft is not too long to fit into the case from the inside. “ I hope this helps.
You should try to put your camera in a place where people can see what your doing and not your hand or hammer. But I think everything else is good