C5 Corvette Upper Oil Pan Gasket Replacement

Replacing the upper oil pan gasket on my 2004 c5 corvette
Lower Pan Gasket Replacement:
• C5 Corvette oil change...
Oil Pan Gasket:
www.amazon.com...
ARP Oil Pan Bolts:
www.summitraci...
Engine Support Bar:
www.harborfrei...
Jack Cross Beam:
www.harborfrei...
C5 Corvette Torque Specs:
www.corvette-w...
2004 c5 corvette
Ls1/t56 (manual)
Comp drift cam 54-777-11
Ls6 valve springs
Ls7 clutch
Monster clutch remote bleeder
LT headers
Off road x pipe
SLP loudmouth axle back exhaust
Vararam ram air intake
B&M short shifter
FDF raceshop hydro
Drift HQ dual caliper kit
MSD 2 step
G-stream aero rear wing
Zr1 style front lip
Ligenfelter clutch return spring
Vettelights laser LED taillights
QA1 Coilovers
C6 z06 OE wheels replicas
275/40/17x9.5 front
295/35/18x10.5 rear
Filming Equipment:
iPhone 13 Pro
DJI Osmo Mobile 3 gimbal
GoPro Hero 9
Hotem iSteady pro 4 gimbal
Instagram: @htpjay
/ htpjay
TikTok: @htp_jay
/ htp_jay
Disclaimer: I am not a licensed professional. If you do not feel comfortable doing any of the things featured in this video please contact or seek professional for advice or help.

[@grahamfrost2480]

Jeez, brave soul doing all that and not using a lift and filming whilst doing it! Fair play to you👏🇬🇧

[@peterb4143]

Props to you bro not a fun job. Had to do it while I was replacing cam and damaged lifters and had a surprise melted piston I had to replace via pushing it out from the bottom. I probably did it wrong and am still leaking a little oil either from the front where it meets the timing cover or because I didn’t buy a timing cover alignment tool and it’s ever so slightly off. It’s a small but consistent leak so I’m not worried about it worsening since everything is new.

[@doolallyproductions7234]

Put wood on the engine brace at least and use a drill on the rivets and put the oil pan on a rag or some type of soft surface other than that good job👍

[@HTPJay]

Thank you

[@vitalirider707]

How much hour you do this?

[@HTPJay]

About 6 hours

[@muggles_moto8284]

Did you rivet the gasket back in place?

[@HTPJay]

No

[@muggles_moto8284]

@@HTPJay thank you. I’m about to do this job and wasn’t sure if it needed it or not

[@JacobLambeCarGuy]

One very important question is do you know JESUS CHRIST AS YOUR PERSONAL LORD AND SAVIOR?