Engine failure to start due to a bad Relay
Vložit
- čas přidán 7. 09. 2024
- If your starter relay has gone bad, the electrical signal will never make it from the battery to the starter motor. As a result, your engine won't turn over - no matter how many times you press the run key. A faulty relay often produces an audible clicking sound when you press the run key or if you have a car with an ignition switch when you turn the key on to start the engine possible to hear it.
Generator Repair videos :
• Generator Repair Videos
Hi sir, useful and informative
Very helpful Sir. Thank you
Congratulations 🎉
Thanks sir .very informative
Thankyou for the video, please do the testing by Multi metre
Noted!
Sir, can I ask for a wiring diagram of the same unit. Our unit at site is P200-2.
We have a problem with our fuel solinoid voltage supplies.no voltage showing whilst starting and engine won't start.
Thank you sir
Greetings
Thank you for your request
Please send me an email to
north.jayhoon@gmail.com
I will send you the wiring diagram.
All the best
How to problem alarem high volteg battrie ....?
Thank you for your enquiry!
If your generator's controller indicates/ warning high battery alarm, definitely you need to check DC alternator .
An alternator's output is controlled by an integrated voltage regulator, which is designed to prevent overcharge.
You may have a faulty voltage regulator and it does over charge your battery.
Thank you for the video. Please kindly answer this question👉👉Why doe a Cummins generator controller(ps0600) reset the running hour and change the genset configuration by itself? Thanks!
Dear Sir
Thank you for chosen DIY & Fix it
Your controller may not programmed / calibrate well ,
By pressing ok and reset key you are gonna start calibration
I wish to have PS0600 or PS0500 to make a You Tube video.
@@northjayhoon9789 Grateful to your support🙏 I tried to enter into configuration mode and seen "J16-9 SENSOR SEL" changed into "Not connected" inside Genset configuration after the reset. When the reset occurs again the configuration is changed and due to this when a remote start signal is received the DG cranks but fails to start. Hopefully waiting you next video on 0ps600 controller.🙏
Hello sir.new subcriber.
👏👏