INSTALLING PERTRONIX ELECTRONIC IGNITOR II IGNITION in 1970 CORVETTE
Vložit
- čas přidán 6. 09. 2024
- Hey Folks! Welcome back to the channel. Today I am installing a Pertroxix Ignitor II electronic ignition with adaptive dwell along with a Pertronix Flame Thrower II coil in my 1970 Corvette. I installed this Pertronix 91181 electronic ignition and 45011 Flame Thrower II coil in my Corvette's distributor to eliminate the need for the old points and condensor.
#PERTRONIX #ELECTRONIC IGNITION #CORVETTE
Installing PerTronix 1181 Ignitor or 91181 Ignitor II into standard Delco Remy Distributor
• Installing PerTronix 1...
PerTronix 45011 Flame-Thrower II 45,000 Volt 0.6 ohm Coil
amzn.to/2zYD4x7
PerTronix 91181 Ignitor II Adaptive Dwell Control for Delco 8 Cylinder
amzn.to/37T3w83
** I am an Amazon affiliate. I make a small commission from sales through my Amazon links that goes to support this channel. **
Thanks for checking out the video. I'd be interested in hearing what your experiences are with an electronic ignition setup. Let me know in the comments.
Hey if you shim your gear on the distributor you are not going to get the pin on the gear back in,
Hi,
Do you know whether this ignition mechanism works for a 1993 nissan pick up distributor ?
Regards from México
Sorry, I don't know. You can check with the manufacturer.
@@KevinNadeau it will. You just need to order from the manufacturer
Where do the two wires go? What about a resistor block?
Is there a part 2?
For what it cost you for that kit, you could have went to your local scrap yard and bought a HEI distributor with the coil in the cap. Hooked up the 12v lead to it and been done with it. Cheaper and the ignition modules are cheaper to buy than having to get a new kit when this one fails.
What if he wanted his car to retain the original look of a points distributor? Cheaper doesn't always mean better.
It's a tach drive distributor so it's harder to find
@@brucedevrous6993 Every HEI ignition system has a tack lead on the distributor
@@bobmorton4633 thanks a lot I saw another guy splicing a wire in and I couldn't figure out why, great video!
I think this video only sets up,the. Questions we aLl have
I've had this setup for almost 2 years now, and I don't have any complaints 👍