How much are you retracting on your extruder change? My Gemini S oozes badly unless I drop temps, but then at the change the extruder sits over the print as it heats up. I am using an earlier version from before they added the metal wipes, the older one uses brushes, and I am not sure if they have done any additional hardware or firmware updates.
I changed to capricorn tubing, but mine are around 1mm 2mm retraction. I have issues with Gaps in layers most likely due to linear advance or bad esteps(which you can't calibrate on these)
How much are you retracting on your extruder change? My Gemini S oozes badly unless I drop temps, but then at the change the extruder sits over the print as it heats up. I am using an earlier version from before they added the metal wipes, the older one uses brushes, and I am not sure if they have done any additional hardware or firmware updates.
I changed to capricorn tubing, but mine are around 1mm 2mm retraction.
I have issues with Gaps in layers most likely due to linear advance or bad esteps(which you can't calibrate on these)
Hello
I bought a Tronxy Gemini S IDEX.
And I can hardly print with the print is terrible. What firmware do you have on here ?
i have the stock firmware, what are the issues your having
@@TheBreadboardca The print is just awful. Can I send you any way a picture of the print to show you
@@Golf3gti1 peter@thebreadboard.ca