Velikost videa: 1280 X 720853 X 480640 X 360
Zobrazit ovladače přehrávání
Automatické přehrávání
Přehrát
Thanks, good stuff. However I always check to clean air filters first, may even look first at the s plug
I love the way these scream I have a echo 355 as my in tree saw but I'm a non climber
Sounds wicked!
mean little machine :)
My old neighbor got a ms200t for free lucky guy it was left behind on one of the electrical and bs he was working on
I just got one for free too. A friend bought a new one and gave me his. Was still in very good condition. He bought the new one cause he got 50% off.
Nice job guys!
thanks man
What mods does this saw have?
Do you know the factory setting for the la screw? I have a rebuild that wont idle
Did you figure it out with LA screw?
@@norbaggar not yet, i can either start it on 2 and a half turns, and then turn the L up quarter to half a turn, but doesnt run great, bogging etc. Or 6 turns out on the LA but still have bad throttle response
@@jimmytree5417 Yes, struggle with the same. Have tried different settings for hours, bogging and low throttle response.
Whats a good initial setting for the idle? How many turns out from seated? Thanks
Default 1 turn out from all the way in out both high and low speed screws
Then fine turn the l to start nice and run nice
Good Stuff!!
thank you sir
This guy is a idiot
The 200t is not the easiest saw to tune.
Andrew Ream try tune the 201t..
The 201 t is not easy to tune especially at high rpm for me.
Lucas Corona 👍you right compa 😁👍
Thanks, good stuff. However I always check to clean air filters first, may even look first at the s plug
I love the way these scream I have a echo 355 as my in tree saw but I'm a non climber
Sounds wicked!
mean little machine :)
My old neighbor got a ms200t for free lucky guy it was left behind on one of the electrical and bs he was working on
I just got one for free too. A friend bought a new one and gave me his. Was still in very good condition. He bought the new one cause he got 50% off.
Nice job guys!
thanks man
What mods does this saw have?
Do you know the factory setting for the la screw? I have a rebuild that wont idle
Did you figure it out with LA screw?
@@norbaggar not yet, i can either start it on 2 and a half turns, and then turn the L up quarter to half a turn, but doesnt run great, bogging etc. Or 6 turns out on the LA but still have bad throttle response
@@jimmytree5417 Yes, struggle with the same. Have tried different settings for hours, bogging and low throttle response.
Whats a good initial setting for the idle? How many turns out from seated? Thanks
Default 1 turn out from all the way in out both high and low speed screws
Then fine turn the l to start nice and run nice
Good Stuff!!
thank you sir
This guy is a idiot
The 200t is not the easiest saw to tune.
Andrew Ream try tune the 201t..
The 201 t is not easy to tune especially at high rpm for me.
Lucas Corona 👍you right compa 😁👍