How To Remove and Install Your Leap V2 Arms and Replace Arm Glides

This video shows you how to properly install the arm glides on Steelcase's V2 leap.
0:00 introduction
0:10 Disassembly
1:15 Installing arm glides
1:27 Re-assembly
2:00 Final Remarks
1. Take a flat head screw driver and place it in the slit under the arm rest and gently twist and pull out from the chair.
2. Tap or push the plastic housing up away from the arm to reveal the inside of the arm.
3. depress the black plastic clip in the slot and at the same time press the button on the arm and pull the arm out.
4. Pull cover off from arm to reveal the slots where the arm glides go.
5. insert arm glides in the spaces provided at the bottom of the arm.
6. Put the cover back on the arm base at an angle and turn the cover and push down so that it lines up perfectly with the arm base. Make sure that the cover on the bottom is secure.
7. Insert the arm back into the arm base by pressing the button on the arm and sliding in the arm into the base.
Crandall Office Furniture has been remanufacturing Steelcase & Herman Miller office chairs since 2002, and since then has grown to become the largest remanufacturer of high-end office seating in the United States. We see and work on thousands of these chairs every year, which gives us a unique insight into how they stand up to long term use, where they fail, and how to fix them. If you're looking to learn more about high end seating, you're in the right place!
► Learn More About our Remanufactured & Refurbished Chairs and our company at: www.crandalloffice.com

[@NewYears1978]

Should have showed the tightness after the install =D

[@ekillops22]

Are these clips available for purchase from Crandall?