Whirlpool Electric Dryer Main Control Board WPW10654005
Vložit
- čas přidán 28. 04. 2016
- Buy part WPW10654005
www.repairclinic.com/PartDetai...
This video provides step-by-step repair instructions for replacing the main control board on a Whirlpool electric dryer. The most common reason for replacing the control board is if the dryer won’t start.
Learn how to troubleshoot your dryer:
www.repairclinic.com/RepairHel...
This control board replacement video is applicable to the following brands:
Whirlpool
Tools needed: 5/16th inch socket or nut driver, putty knife
Connect With Us!
plus.google.com/+repairclinic
/ repairclinic
/ repairclinic
/ repairclinic
Join our VIP email list for discounts and money-saving tips: tinyurl.com/pnnh3be
Check out our blog: www.DIY.RepairClinic.com
Don't forget to like and comment on this video and subscribe to our channel! - Jak na to + styl
I got 4 red wire without a hole to plugs them into can anyone help me
How do you determine that the old one is gone? The only fault code I received was a flashing L-2 everything else checks out fine. Circuit board looks like new.
Turn off the power remove the board on the backside of the board you’ll probably see a black spot the trace probably burnt off the relay. I see lots of videos on this and mine just did this so I’m gonna have to order a new relay and replace it. Whirlpool is wonderful quality the whole board is no longer available however I will change the relay itself and soilder a new one in place. the dryer is not even 10 years old I don’t even think it’s six years old in fact mine in my case.
@@justaviewerortwo2924 Just curious, how did you diagnose it was a failing relay on the board? My dryer motor will have a small rotation, then stop. Ruled out thermal fuse, thermistor and drive motor. I suspect it's something in the control board but do not have any error codes. Thank you in advance if your respond. Blessings! :)
@@MOMENTUMdnb I seen some reason that those motors had a built-in switch relay maybe that could be feeling on your motor you can always pull the motor out and have a electric motor shop check your motor to make sure it’s fine they will rule out the motor. On my control board my relay had burnt traces and blew the solder off.
@@justaviewerortwo2924 how did you get the circuit board out of the plastic holder?
@@nickmeistersa123456 there is plastic tabs on the out area of the white casing facing the board. Little tabs just push inward towards outside do one at a time gently lifting the board upwards. I believe and maybe a screw on the board.
At 1:05 to the left of the orange box I cannot remove the connector. Not sure what the trick is.
trencher7 same here
Seriously! Has anyone figured out the trick here?!
Same here! Anyone ever figure this out?
Pull hard
Rock it side to side while pulling with a lot of force. You may have to use a pry tool if your fingers are not strong.
"This video provides step-by-step repair instructions for replacing the main control board on a Whirlpool electric dryer. The most common reason for replacing the control board is if the washer won’t start."---Not sure why I would replace the main control board on the DRYER, if the WASHER won't start.