90 Honda Goldwing Rear Master Cylinder and Brake Pads Replace Part2
Vložit
- čas přidán 25. 05. 2023
- In this video we replace the rear brake master cylinder, brake pads and bleed the brakes, then test the bike after sitting for 10 years.
You can also check out my Copart damaged 2013 Ford Raptor DIY driveway frame swap series beginning with Part 1 at the link below.
www.youtube.com/watch?v=CPDzj...
If you want to see some of my other content, I resolve a blown engine issue on a Miller Bobcat 225 Welder Generator, I rebuilt an old Lincoln WeldanPower 150 welder/generator, I revive a 1970s Toyota Forklift and reassemble a barn find 1929 Model A rebuild project. Please click the links below to start seeing those episodes.
• Miller Bobcat 225 Trou...
www.youtube.com/watch?v=PZN0H...
• 70’s Toyota Forklift R...
• 1929 Ford Model A Rebu...
#EasySimpleMechanic #ToyotaForkLift #MillerBobcat225 #ModelA #FordModelARebuild #ModelARebuild #ModelAAssembly #WeldanPower #Briggs&Stratton #Goldwing - Zábava
Never seen one of your Videos and got this recommended with 0 views. Im amazed by the stuff the youtube algorithm does. Keep up the good work.
Just put out this video early this morning. Thanks for watching it though. I hope you liked it and subscribe to the channel..
I changed the master brake cylinder on my ‘95 GL1500SE - fun time getting that rear line connected, for sure. The forklift wld have been nicer than laying on the floor! Will wait until you lube up your rear splines & check the U-joint before attempting mine.🧐 Good videos!
I watched this video to see how you reinstall the master cylinder, I saw everything but that. I have spent several hours trying to finish this job.
First of all, thanks for watching and commenting on the video. Starting at 8:34, I show having to remove the plastic piece on top of the cylinder, using some plastic ties to hold the cylinder just right, and using a ratchet box end wrench to get the back brake line installed to get it in. It definitely was a challenge and I commend you for attempting this. I was definitely not the easiest job I have done. Good luck....😀
Greetings
As always another fantastic detailed video 🇺🇸🍾🎉🇺🇸
Keep producing more videos
I’m working on this right now. Since I have to do way more (carburetor, gastank, rearbrake, driveshaft, timingbelt, valves, frontbrakes, and so on, yes the bike didn’t run for more then 8 years now, I disassembled most of the bike now. But thanks for some insights.
Thanks for watching my videos and commenting... Good luck with your revival project.....😊
good job
Thanks for watching and commenting on my videos.....😀
I'm having a hard time finding the master cil. For my 1992 goldwing any clues?
Thanks for watching my videos. Here is the link for the one I bought for mine on Ebay😃😃😃: www.ebay.com/itm/125600167258