Man i have to say, i am bad at applying screen protectors, this was the first one that i actually managed to worked out and it was in a FOLD, thanks to this brand i didnt have to spend time without my phone. Ordering two more for the future.
Very satisfied with this product. I installed yesterday on my Fold 4 and the initial results were not good because I didn't carefully squeegee the depression at the fold area and ended up with bubbles, and worse, blurry smudged areas where I tried to push the bubbles out. Thought for sure I'd need to order another and try again. But after a day, it looks pretty good actually. The blurred areas where I disturbed the adhesive have cleared up and the bubbles are practically non-existent and now only visible when the screen is off. I may try again with a new film but I'm in no hurry as it looks pretty good!
2 weeks later and the protector looks even better! Bubbles are gone and there's only the slightest tiny spots that are unnoticeable unless you're looking for them. Amazing
Followed this instruction, but the hinge protector was damaged after 4 days by constant opening and closing of the main display. I had to take it off eventually. I guess the hinge can never be fully protected without an actual hinge protector from the case
Best way to apply this is before starting the process, open a stream of hot water in the bathroom so it's all foggy and wet. Then leave it to clear out so all the dust goes down. The front screen one got all scratched while pushing it in. The inner is fine. The hinge protection seems pretty useless.
We are currently in the process of developing the Z Foldable Series 6, and we would greatly appreciate your insights and advice to enhance our product. Thank you.
The version I got doesn't have a top film to remove so I ended up ruining it. Looks like the ends are supposed to just detach. No matter how hard I tried, no "top film" came off.
At first I thought this too, but then I realised a super thin layer actually stayed on the screen even though it didn't look like it first. Look super carefully to see if it didn't leave the screen protector on, just that it didnt look like it so you didnt notice
Bought one of these. Followed installation instructions to the letter. After only 1 hour it came away from the crease and a large air bubble opened up which would not go away. Waste of money
theres no pull away tab for the second side on these any more, so they are completely useless. Have to cut the end with scizzors leaving them jaggard and lift immediately. DO NOT BUY!
Trash product wasn't cut to where it could even un stick from the applicator it was just one giant piece of uncut film, and the adhesive wouldn't stick to the phone
Před 2 měsíci
This product is a scam. I installed all of this flawlessly. The hinge/spine protector peeled otself off after opening and folding the phone a couple of times. The front protector is a weird soft plastic. It looks horrible and there is a hotozontal line that will not go away. The inner protector is of a better harder plastic than the front one.but has weird spots in it. And no, they're not air bubbles. This is an expensive product that is worthless.
Man i have to say, i am bad at applying screen protectors, this was the first one that i actually managed to worked out and it was in a FOLD, thanks to this brand i didnt have to spend time without my phone. Ordering two more for the future.
Very satisfied with this product. I installed yesterday on my Fold 4 and the initial results were not good because I didn't carefully squeegee the depression at the fold area and ended up with bubbles, and worse, blurry smudged areas where I tried to push the bubbles out. Thought for sure I'd need to order another and try again. But after a day, it looks pretty good actually. The blurred areas where I disturbed the adhesive have cleared up and the bubbles are practically non-existent and now only visible when the screen is off. I may try again with a new film but I'm in no hurry as it looks pretty good!
Thank you, buddy!
2 weeks later and the protector looks even better! Bubbles are gone and there's only the slightest tiny spots that are unnoticeable unless you're looking for them. Amazing
Followed this instruction, but the hinge protector was damaged after 4 days by constant opening and closing of the main display. I had to take it off eventually. I guess the hinge can never be fully protected without an actual hinge protector from the case
Do you guys sell the inner screen seperate ialready bought the kit but would like to by extra inner screen protectors??
Best way to apply this is before starting the process, open a stream of hot water in the bathroom so it's all foggy and wet. Then leave it to clear out so all the dust goes down.
The front screen one got all scratched while pushing it in.
The inner is fine.
The hinge protection seems pretty useless.
We are currently in the process of developing the Z Foldable Series 6, and we would greatly appreciate your insights and advice to enhance our product. Thank you.
Purchase the dome premium film from my Galaxy Z4 and the front screen does not have a cut out for the camera. Is that normal?
Yes.
The version I got doesn't have a top film to remove so I ended up ruining it. Looks like the ends are supposed to just detach. No matter how hard I tried, no "top film" came off.
At first I thought this too, but then I realised a super thin layer actually stayed on the screen even though it didn't look like it first. Look super carefully to see if it didn't leave the screen protector on, just that it didnt look like it so you didnt notice
The film didn't break away properly at the tab and I had to use scissors to cut enough away to be in the dimensions... trash.
which one's better... the Dome Premium Film (TPU) or the Dome Premium Gen Film (PTE)?
Bought one of these. Followed installation instructions to the letter. After only 1 hour it came away from the crease and a large air bubble opened up which would not go away. Waste of money
Lots of bubbles left on my Fold 4 inner screen. I am asking for a full refund on Amazon.
It takes a little bit of pressure to get the front screen 99 percent bubble free.
All 3 attempts failed. €50 wasted lol.
theres no pull away tab for the second side on these any more, so they are completely useless. Have to cut the end with scizzors leaving them jaggard and lift immediately. DO NOT BUY!
The original samsung has that too now! Totally wreckes the film.
P
Trash product wasn't cut to where it could even un stick from the applicator it was just one giant piece of uncut film, and the adhesive wouldn't stick to the phone
This product is a scam. I installed all of this flawlessly. The hinge/spine protector peeled otself off after opening and folding the phone a couple of times. The front protector is a weird soft plastic. It looks horrible and there is a hotozontal line that will not go away. The inner protector is of a better harder plastic than the front one.but has weird spots in it. And no, they're not air bubbles. This is an expensive product that is worthless.