250cc scooter thermostat change and coolant antifreeze burping.

Sdílet
Vložit
  • čas přidán 11. 10. 2016
  • 250cc scooter thermostat change and burping procedure. Overheating fix.

Komentáře • 54

  • @truerushblast
    @truerushblast Před 5 lety +12

    We can do with out the music exsplain what the f u are doin

  • @miguel360kmc
    @miguel360kmc Před 5 lety +3

    Also the seeing what your doing only not a step bye step talk through was more than sufficient for me a none mechanic that knew nothing before purchasing my first 50cc scooter less than a year ago.

  • @nganpath
    @nganpath Před 4 lety +6

    More like a music video than a tutorial. Fuzzy pics and the frames move real fast. Not much help.

  • @user-tg1qo6vr9j
    @user-tg1qo6vr9j Před 5 lety +1

    영상 잘 봤어요. 고마와요^^

  • @andrewpal520
    @andrewpal520  Před 7 lety +4

    I guess now you heard of Beck (the music). i made this vid last minute while repairing. Drain, remove hose, remove thermostat housing, replace thermostat make sure air hole is on top of thermostat when installing new one. reattach hose, fill coolant, start engine let warmup once warm thermostat should open. add more coolant and cap, check to make sure coolant fan turns on.

    • @davidolmos7110
      @davidolmos7110 Před 5 měsíci

      if i wanna flush my coolant would i have too still remove the hose or can i just drain, and then fill coolant

    • @andrewpal520
      @andrewpal520  Před 5 měsíci

      @@davidolmos7110 No you don't need to remove the hose just drain it and fill it up should be good.

  • @andrewpal520
    @andrewpal520  Před 7 lety +4

    i used a 8mm wrench. it wasnt easy. i could only turn it a little at a time. i used the round end. then to put it on i used a socket to get it to start and finished with the wrench.

  • @enlightenedillumination

    How is the fuel vacuum setup..need vfc to know

  • @miguel360kmc
    @miguel360kmc Před 5 lety

    How did your scoot act when hot?
    I think i have some type 🔥 issue on my 250rs t-scoot 1st off my gauges dont work right at all so cant trust them (its a gy6) but after a cold start 1st try some gas it starts have to feather the gas for a minute when its cold out to keep it running. Than it runs fine good speed sound etc. But after say 10miles or a few miles over 40mph it starts shaking when stopped ( idling) up and down not really a rev up and down than when shutting off i got a afterfire! So i would let it run for a min before shutting it off doing this i got it on the center stand after it got 🔥 hot and started shaking and seen the wheel was going fast! Like i had a way to high of a idle setting or something only does it when hot.. Striping her down now to check spark/plug/cdi /air filter- did oil change 50miles ago. Only use 93.gas but cleaning carp aswell

    • @andrewpal520
      @andrewpal520  Před 5 lety

      It's probably your clutch. They are pretty cheap on eBay usually $20. The pins in the clutch that allow it to open and close usually loose there grease because of bad seals. Iwould get new clutch variator and belt.

    • @miguel360kmc
      @miguel360kmc Před 5 lety

      Yeah ill be fixing it slowly. For now I've fallen back in love with my trike 49.cc rebuilding it now from stock bbk full deal.. Its just sooo much fun in the snow! Its weight is prefact just eats snow / ice like nothing

  • @andreknox2969
    @andreknox2969 Před 3 lety

    Whatss makes the bike shake if there's no anti freeze in it

  • @joejosiah
    @joejosiah Před 7 lety +1

    How did you get to the bolt on the back of the thermostat?

    • @pcofranc
      @pcofranc Před 7 lety

      I put the bolt in before putting the thermostat all the way down and started to thread it.

  • @hjaltiful
    @hjaltiful Před 5 lety

    is the white tank in minute 3:18 for water also ? I have znen 250cc just wondering what this tank is

    • @andrewpal520
      @andrewpal520  Před 5 lety +1

      Yes it's for water/coolant. It's the overflow tank. When your engine gets hot coolant flows into that bottle then when it cools it goes back into your radiator.

    • @hjaltiful
      @hjaltiful Před 5 lety

      @@andrewpal520 thanks

  • @RitchieMonroe
    @RitchieMonroe Před 6 lety +3

    Thanks. Can't believe the negative comments and the thumbs down. If you can't do this by watching this video, it's time to sell your tools.

  • @NoEmpathyInstro
    @NoEmpathyInstro Před 4 lety

    what is the white tank on the floor next to gas cap !!!please respond

    • @andrewpal520
      @andrewpal520  Před 4 lety +1

      My gas tank is under the seat were the passenger sits but I think your talking about the coolant overflow tank on my bike its towards the front between your legs. Thats for the coolant to have room to expand when its hot (running). Just make sure its halfway full when your bike is cool.

  • @gBoogieDaBoogieMan
    @gBoogieDaBoogieMan Před 4 lety

    My over heats light comes on as soon as I turn my bike on it’s a 250cc venom/falcon.. and I changed the carburetor and thermostat.. light still coming on..

    • @andrewpal520
      @andrewpal520  Před 4 lety

      Maybe it's the coolant temperature sensor it's on the housing for the thermostat.

    • @austindeaton1940
      @austindeaton1940 Před 3 lety

      If your still having the issue check water pump

  • @sethfrost3265
    @sethfrost3265 Před 3 lety

    How much should a Helix burn, is it normal to be 4/100

  • @dropworld922
    @dropworld922 Před 5 lety

    HEY WHERE DOES THAT OTHER TUBE GO WERE YOU FILLING IT,I HAVE THE BIG ONE HOOK UP WERE DOES THE LITTLE ONE GO CAN ANY ONE HELP ME P.LEASE

    • @andrewpal520
      @andrewpal520  Před 5 lety

      On mine the little one goes from the thermostat housing to the carb to a little L shaped piece of aluminum that has 1 screw that holds it to the carb then from the carb it goes to the filler neck. It circulates a little coolant to keep the carb from freezing up. It also let's the air bubbles escape from the system. On mine the L shaped piece on the carb was a little clogged make sure you can see the coolant flowing out the little hose to the filler neck.

    • @dropworld922
      @dropworld922 Před 5 lety

      @@andrewpal520 thanlks bro i have 3 one big one that gos to radator ont that go's to to over flow tanks and the one were talking about i hook it up to the carb,cause i notice ther was coolant coming out my car,is that wright,is there any way i can send you pics,your email address are somthing,i bought one off a lady did a total break down put new parts and all,today i added a elearic fuel pump cause i wasnt getting no gas to carb,but that was one of the issue i couldnt figure out where it gos

  • @blipco5
    @blipco5 Před 4 lety +2

    I for one love the music. 👍

  • @dp8461
    @dp8461 Před 6 lety

    Does your thermostat housing have a small line going to the carburetor?

    • @andrewpal520
      @andrewpal520  Před 6 lety

      Yes it goes to the carb to a small aluminum L shaped thing that screws on. Then to the filler cap. It's keep your carb from freezing up.

    • @dp8461
      @dp8461 Před 6 lety

      Andrew Pal Ok thank you

  • @MotoMiles
    @MotoMiles Před 3 lety +1

    Good grief the music .. great tech work but for crying out loud..

  • @barneyrubble4827
    @barneyrubble4827 Před 3 lety

    Camera is allover the place bro, mak in me dizzy

  • @clavo3352
    @clavo3352 Před 3 lety +1

    Nice try. Please try again; this is an important video! Loose the music. Slow down the camera swings.

  • @TroyGabe
    @TroyGabe Před 3 lety

    Hi is this a Honda reflex.

    • @andrewpal520
      @andrewpal520  Před 3 lety

      My bike is a jonway 250 it's a chinese clone of a honda helix also known as a cn250.
      I think a honda reflex has a different motor it's called a nss250 some parts look the same but it is different.

  • @jay_tarantula899
    @jay_tarantula899 Před 5 lety +3

    Who else thumbed down for the music?

  • @josephkolaski4912
    @josephkolaski4912 Před 3 lety

    Coolant for a 250? What 250?

    • @andrewpal520
      @andrewpal520  Před 3 lety

      My bike is a jonway 250 with a cn 250 motor. It's a chinese honda helix clone.

    • @josephkolaski4912
      @josephkolaski4912 Před 3 lety

      @@andrewpal520 sorry Andrew. I'm ripped off paying 2480 for a 250 Morphous scooter and found out my country is going to pay the enemy of Americans to invade my country. And dares my country to invade them so they can accuse of racism. BTW your Chinese are watching how Mexico manipulates us. I'm a Veteran disenfranchised in Californication wanna be Guadalajara Mehico. A preempted strike precursor for China to copy. Maybe we need it. Total nuclear annilation is the liberals dream in reality.

    • @9988ScooterGirl
      @9988ScooterGirl Před 3 lety

      @@josephkolaski4912 "Kolaski"? I suspect YOUR ancestors didn't come over on the Mayflower.

  • @robertmarsh5786
    @robertmarsh5786 Před 3 lety

    Mute

  • @youpi1949
    @youpi1949 Před 7 lety +6

    Very hard to follow. Didn"t help much.

  • @silviofontana3666
    @silviofontana3666 Před 3 lety

    nudda, music is not good

  • @mattgonzalez1580
    @mattgonzalez1580 Před 2 lety

    Crap

  • @9988ScooterGirl
    @9988ScooterGirl Před 3 lety

    Really appreciate the intention but it's not a very useful video. More of a headache inducer than anything else.

  • @EpicMedia7
    @EpicMedia7 Před 6 lety +2

    Gave you a thumbs up but then cussing in the music so thumbs down